Abstract:After the efficiency of organic photovoltaic (OPV) cells achieved more than 10%, the control of stability and degradation mechanisms of solar cells became a prominent task. The improvement of device efficiency due to incorporation of a hole-transport layer (HTL) in bulk-heterojunction solar cells has been extensively reported. However, the most widely used HTL material, PEDOT:PSS is frequently suspected to be the dominating source for devices instability under environmental conditions. Thereby effects like photooxidation and electrode corrosion are often reported to shorten device lifetime. However, often in environmental device studies, the source of degradation, whether being from the HTL, the active layer or the metal cathode are rather difficult to distinguish, because the external diffusion of oxygen and water affects all components. In this study, different HTLs, namely prepared from traditional PEDOT:PSS and also two types of molybdenum trioxide (MoO3), are exposed to different environments such as oxygen, light or humidity, prior to device finalization under inert conditions. This allows investigating any effects within the HTL and from reactions at its interface to the indium-tin-oxide electrode or the active layer. The surface and bulk chemistry of the exposed HTL has been monitored and discussed in context to the observed device physics, dynamic charge transport and spatial performance homogeneity of the according OPV device. The results show that merely humidity-exposure of the HTL leads to decreased device performance for PEDOT:PSS, but also for one type of the tested MoO3. The losses are related to the amount of absorbed water in the HTL, inducing loss of active area in terms of interfacial contact. The device with PEDOT:PSS HTL after humid air exposure showed seriously decreased photocurrent by micro-delamination of swelling/shrinkage of the hygroscopic layer.

Effect of Transition Metal Oxide Anode Interlayer in Bulk Heterojunction Solar Cells

A highly efficient transition metal oxide layer for hole extraction and transport in inverted polymer bulk heterojunction solar cells

Effect of Electron Collecting Metal Oxide Layer in Normal and Inverted Structure Polymer Solar Cells

Effect of Molybdenum Oxide Anode Buffer Layer on the Performance of Inverted Small Molecular Organic Solar Cells

Crystalline Silicon Heterojunction Solar Cells with Metal Oxide Window Layers

An Ultraviolet‐Deposited MoO3 Film As Anode Interlayer for High‐Performance Polymer Solar Cells

MoO3–Au Composite Interfacial Layer for High Efficiency and Air-Stable Organic Solar Cells

Metal-Oxide Based Solar Cells

Simulation of High Efficiency Silicon Heterojunction Solar Cells with Molybdenum Oxide Carrier Selective Layer

Influence of Environmentally Affected Hole Transport Layers on Spatial Homogeneity and Charge Transport Dynamics of Organic Solar Cells

The Dependence of the Cathode Architecture on the Photoactive Layer Morphology in Bulk-Heterojunction Polymeric Solar Cells

Effect of electrical properties, transmittance and morphology of ITO electrode on polymer solar cells characteristics

Unveiling and Modulating the Interfacial Reaction at the Metal-Hole Conductor Heterojunction toward Reliable Perovskite Solar Cells

Numerical Study of Metal Oxide Heterojunction Solar Cells

Molybdenum Oxide Particles Doped in Hole Transport Layer to Enhance the Efficiency of Flexible Polymer Solar Cells

Interface Engineering of Organic Schottky Barrier Solar Cells and Its Application in Enhancing Performances of Planar Heterojunction Solar Cells.

Impact of AlO x Dielectric Layer on Performance in Two-Dimensional Perovskite Photovoltaic Devices

Influence of Electrode Interfacial Buffer Layers on Thermal Stability of P3HT:PC61BM Solar Cells

Effect of CsF Interlayer on the Performance of Polymer Bulk Heterojunction Solar Cells

Solution-Processed MoO3:PEDOT:PSS Hybrid Hole Transporting Layer for Inverted Polymer Solar Cells

Study on Perovskite Solar Cells with MoO3Anode Buffer Layer