Abstract:Infeed swaging is a type of rotary swaging process. It is usually used to reduce the cross section from the beginning to the end of the tube. Compared with the infeed swaging with mandrel, the infeed swaging without mandrel has the advantages of less-loading, chipless forming, giving high production rate and low tool costs. It has been widely used in aeronautic and automotive industries. In this paper, using the finite element (FE) simulation code, TRANSVALOR FORGE 2011, three-dimensional (3D) FE model and experiment were developed to investigate the stress state and deformation pattern during the infeed swaging of tube without mandrel. Results show that the stress state varies with the regions. In the sinking zone, the stress state in the middle of the tube is biaxial compressive, while that at the other regions is triaxial. In the forging zone, the material suffers from tensile axial stress, compressive thickness stress and circumferential stress. After unloading, tensile residual stresses occur at the forging zone and the inner surface in the sinking zone. The maximum tensile residual stress is 69.5 MPa, which is 77.3% of the yield stress. In the sinking zone, more metal flows radially inside and the deformation type is compressive. In the forging zone, more material tends to flow along the axial direction. The deformation type in the forging zone is tensile. Moreover, experiments were also conducted to validate the FE model. The experimental and simulated results have a good agreement. After the infeed swaging, the microstructure of the tube became smaller and denser. The metal flow lines are continuous, contributing to improve the strength and the fatigue life of tube.

Numerical simulation and experimental study on the tube sinking of a thin-walled copper tube with axially inner micro grooves by radial forging

Experimental and Fem Study on Sinking of Miniature Inner Grooved Copper Tube

Numerical Simulation of High-Speed Spinning of Thin-Wall Copper Tube with Axial Micro-Grooves

Comparison of radial forging between the two- and three-split dies of a thin-walled copper tube during tube sinking

Forming Characteristics Analysis of the Cross-Section of Axially Inner Grooved Copper Tube

Numerical Simulation of Neck-Spinning of Thin-Wall Micro-Grooved Copper Tube

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

FEM Numerical Simulation of Tube Axial Drawing Process

Numerical and Experimental Study on Expansion Forming of Inner Grooved Tube

Evolution of inner wall wrinkle defects in the sinking zone of a thick-walled steel tube during radial forging

Experimental and Numerical Investigation on Axial Hydro-Forging Sequence of 6063 Aluminum Alloy Tube

Numerical simulation and experimental study on non-axisymmetric spinning with a groove at the middle of the tube

Stress State and Deformation Pattern During the Infeed Swaging of Tube Without Mandrel

Finite Element Analysis of Copper Tube Drawing Process Using Diamond-Coated Dies with Fixed Plug

Experiments and Finite Element Simulation on Mandreless Ball Neck-spinning of Thin-walled Copper Tube

Experimental Study of the Tube Axial Compression Forming Process with Free Dieless Deformation

Investigation of Thickness Variation in Axial Hydro-Forging Sequence for Variable-Diameter Tubes

Forming Defects of Axial Inner Micro-Grooved Copper Tubethrough Two-Split Dies Rotary Swaging Process

An Incremental Die Forging Process for Producing Helical Tubes

Numerical Simulation and Experiment Study on Tube Spinning of GH625 Reducer Tube

Multi-Mode Damage and Fracture Mechanisms of Thin-Walled Tubular Parts with Cross Inner Ribs Manufactured Via Flow Forming