Abstract:It may be a potential way to realize high-efficiency and high-quality local loading forming on the double-action press. However, the deformation characteristics and forming quality of transitional region are the weak link during forming process. In this work, the material flow, deformation inhomogeneity, forming defect of transitional region, and their dependences on the local loading parameters were quantitatively investigated by FE simulation. It is found that due to the constraint clearance, the web material would undergo twice transverse flow with opposite directions successively in two loading steps. This phenomen is basically the same as that in the local loading forming on single-action press, while the extent of transverse material flow on double-action press is greatly smaller. Finally, the transitional region presents different strain distributions in various sub-regions. Region A and region C present a symmetric strain concentration area at rib root, while region B presents a slant strain concentration area at the middle rib. The forming quality on double-action press is better than that on the single-action press. Only a cavum defect at left rib is produced because of the transverse material flow. Constraint clearance plays the most important role in the deformation characteristics and forming quality during the local loading forming on double-action press. The transverse material flow and cavum defect can be suppressed by decreasing the constraint clearance, but the deformation inhomogeneity would increase to some extent at the same time. In addition, the friction factor and radius of left rib are the second significant factors. Increasing the friction factor and radius of left rib is helpful to suppress the transverse material flow and cavum defect, respectively. As far as the forming quality of transitional region is concerned, it is a better way to conduct the local loading forming on double-action press than on single-action press. The results will provide basis for the design of processing parameters in the local loading forming of Ti-alloy rib-web component on double-action press.

Numerical and experimental investigation on precision forming of ribbed tube by cold drawing process

Investigation of cold drawing process of thin-walled ribbed steel tube

Effect of cold process drawing parameters on the formability and microstructure of ribbed cladding tubes

Rib Filling Behavior in Flow Forming of Thin-Walled Tube with Helical Grid-Stiffened Ribs

Investigation on formability of ribbed tube and its forming quality by MPCD process

Precision Forming of Long-Axis Forgings with Rib-Web Sections Via Billet Optimization Based on Flow Characteristics

Deformation Characteristics of Transitional Region During Local Loading Forming of Ti-alloy Rib-Web Component on the Double-Action Press

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Forming the Transverse Inner Rib of a Curved Generatrix Part Through Power Spinning

Unequal-thickness Billet Optimization in Transitional Region During Isothermal Local Loading Forming of Ti-alloy Rib-Web Component Using Response Surface Method

Multi-pass rolling-extrusion of large-scale thin-walled square tube with longitudinal inner ribs

Research On Isothermal Precision Forming Processes Of Rib-Web Forging With Local Loading

Study on generating rolling method for manufacturing cylindrical parts with external cross ribs

Research on Isothermal Precision Technology of Rib-Web Forging Parts

Study on the metal flow in power spinning process of parts with transverse inner rib

Experimental Study of the Tube Axial Compression Forming Process with Free Dieless Deformation

Unequal Thickness Billet Design for Large-Scale Titanium Alloy Rib-Web Components under Isothermal Closed-Die Forging

Numerical simulation and experimental study on the tube sinking of a thin-walled copper tube with axially inner micro grooves by radial forging

Sheet Metal Forging Process for Thin-Walled Structures with Crossed Ribs: Process Design, Simulation and a Forming Experiment

Influence of Die Parameters on the Deformation Inhomogeneity of Transitional Region During Local Loading Forming of Ti-alloy Rib-Web Component

Study on Cross Section Geometry of Preform for the Forming Laws of A Symmetrical Rib-Web Component