Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

Investigation on the Structure Profile of Precise Copper Tube by Three-Roll Planetary Rolling Based on Finite Element Simulation Assisted by Machine Learning

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

Technology Optimization Analysis of Three-Roll Rotary Piercing Process for Seamless Steel Pipe

Optimization of Mechanical Properties during Cold Rolling and Wrap-Forming for Metal Helical Tubes

Insight into deformation allocation in the multi-pass roll forming of a double-walled brazed tube

Full-Cross-Section Deformation Characterization of Cu/Al Bimetallic Tubes under Rotary-Draw-Bending Based on Physics-Driven B-Spline Curves Fitting

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Numerical and experimental analysis of edge wave defect control during TA2 circular tube cold roll forming

Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders

Precise local deformation control for UHSS thin-walled component in roll forming

Research on the Mechanism and Processability of Roll Forming

Approach Based on Response-Surface Method to Optimize Lining of Dies Used in 3D Free-Bending Forming Technology

Effect of discrete roller dies on the contour accuracy of profiles in multi-point flexible stretch-bending forming

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Tailoring the microstructure and mechanical properties of Cu-Fe alloy by varying the rolling path and rolling temperature

Learning to Predict Metal Deformations in Hot-Rolling Processes

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

A Study of 3D Finite Element Modeling Method for Stagger Spinning of Thin-Walled Tube

Study on the shear-torsion deformation of rotary tube piercing process for nickel base superalloy