Abstract:In order to improve performance of Organic Light-emitting Diodes (OLEDs) in this paper, the electron injection is enhanced by inserting an ultrathin Alq 3 –LiF–Al trilayer in between the organic layer and the LiF/Al cathode, which is explained by the formation of a thin n-doped Alq 3 layer that improves electron injection. At the same time, a buffer layer using MoO 3 was induced between m-MTDATA and N,N′-bis-[1-naphthy(-N,N′diphenyl-1,1′-biphenyl-4,4′-diamine)](NPB) to prompt hole injection because not only the Highest Occupied Molecular Orbital (HOMO) of MoO 3 is suitable to be used as buffer layer but also the interfacial doping effect of MoO 3 induces interfacial charge transfer complex formation between MoO 3 and NPB. At current density of 20 mA/cm 2 , compared with control device, the current efficiency, power efficiency and luminance of device using ultrathin Alq 3 –LiF–Al trilayer and MoO 3 were increased by 64%, 101% and 63% respectively, while driving voltage was reduced by 26%. After a series of single-carrier devices were made to analyze performance improvement of device using ultrathin Alq 3 –LiF–Al trilayer and MoO 3 , it is found that efficient carrier balance can improve device performance remarkably.

Buffer-enhanced Electron Injection in Organic Light-Emitting Devices with Copper Cathode

Enhancement of Electron Injection in Organic Light-Emitting Devices Using an Ag/LiF Cathode

LiF layer at the interface of Au cathode in organic light-emitting devices: A nonchemical induced carrier injection enhancement

Mechanisms of Injection Enhancement in Organic Light-Emitting Diodes Through Insulating Buffer

Enhanced Hole Injection in Organic Light-Emitting Devices by Using Fe3O4 As an Anodic Buffer Layer

Effect of CsF Buffer Layer on Charge-Carrier Mobility in Organic Light-Emitting Diodes Based on a Polyfluorene Copolymers by Admittance Spectroscopy

Mechanism of improving the performance of organic electroluminescent divices by using CuPc as buffer layer

Highly Efficient Simplified Organic Light-Emitting Diodes Utilizing F4-TCNQ As an Anode Buffer Layer

Enhancing Performances of Blue Organic Light-Emitting Devices Incorporating CuPc As Electron Buffer Layers

Characterization of Organic Electro-Luminescent Devices with Copper Phthalocyanine As a Buffer Layer

A New Kind of Buffer Layer of TiO 2 Self-Assembled Material in Organic Electroluminescent Devices

Efficient Organic-Inorganic Hybrid Hole Injection Layer for Organic Light-Emitting Diodes by Aqueous Solution Doping

Obvious Efficiency Enhancement of Organic Light-Emitting Diodes by Parylene-N Buffer Layer

Performances enhancement in OLEDs by inserting ultrathin trilayer in electron injection structure and using MoO3 as hole buffer layer.

Effect of Nacl Buffer Layer on the Performance of Organic Light-Emitting Devices (Oleds)

Improving Electron Injection of Organic Light-Emitting Transistors via Interface Layer Design

Mechanisms of the Improved Organic Photovoltaic Performance by Using Electron-Transporting Cupc Derivative As Anode Modifying Layer

Dual Role of Lif As A Hole-Injection Buffer in Organic Light-Emitting Diodes

Influence of Hole Injection Structures on Organic Electroluminescent Devices

High-Performance and Operationally Stable Organic Thin-Film Transistors Using Bi-Buffer Layers with Low-Cost Electrodes

Efficient organic light-emitting diodes with teflon as buffer layer