Abstract:The pursuit of enhancing the performance of silicon-based solar cells is pivotal for the progression of solar photovoltaics as the most potential renewable energy technologies. Despite the existence of sophisticated methods like diffusion and ion implantation for doping phosphorus into p-type silicon wafers in the semiconductor industry, there is a compelling need to research spin-on doping techniques, especially in the context of tandem devices, where fabricating the bottom cell demands meticulous control over conditions. The primary challenge with existing silicon cell fabrication methods lies in their complexity, cost, and environmental concerns. Thus, this research focuses on the optimization of parameters, such as, deposition of the spin on doping layer, emitter thickness (Xj), and dopant concentration (ND) to maximize solar cell efficiency. We utilized both fabrication and simulation techniques to delve into these factors. Employing silicon wafer thickness of 625 μm, the study explored the effects of altering the count of dopant layers through the spin-on dopant (SOD) technique in the device fabrication. Interestingly, the increase of the dopant layers from 1 to 4 enhances efficiency, whereby, further addition of 6 and 8 layers worsens both series and shunt resistances, affecting the solar cell performance. The peak efficiency of 11.75 % achieved in fabrication of 4 layers dopant. By using device simulation with wxAMPS to perform a combinatorial analysis of Xj and ND, we further identified the optimal conditions for an emitter to achieve peak performance. Altering Xj between 0.05 μm and 10 μm and adjusting ND from 1e+15 cm-3 to 9e+15 cm-3, we found that maximum efficiency of 14.18 % was attained for Xj = 1 μm and ND = 9e+15 cm-3. This research addresses a crucial knowledge gap, providing insights for creating more efficient, cost-effective, and flexible silicon solar cells, thereby enhancing their viability as a sustainable energy source.

Simulation optimization of P+ layer of back surface field for crystalline silicon solar cell by simulation

Analysis of the Effect of Active Layer Thickness on Polymer Solar Cell Performance Based on Optical and Opto-Electronic Model

Influence of contact characteristics of SnO2/P on fill factor of solar cell

Optimization of Mono-Crystalline Silicon Solar Cell Devices Using PC1D Simulation

Influence of the Compensation Level on the Performance of P-Type Crystalline Silicon Solar Cells: Theoretical Calculations and Experimental Study

Optimization of activated phosphorus concentration in recrystallized polysilicon layers for the n-TOPCon solar cell application

Fabrication of High-Quality Boron-Doped Microcrystalline Silicon Thin Films on Several Types of Substrates

Optimization of Heterojunction Back-Contact (HBC) Crystalline Silicon Solar Cell Based on Quokka Simulation

The Influence of N-Layer on Properties of Microcrystalline Silicon Solar Cells on Flexible Substrates

Impact of Boron Doping Concentration on Tunnel Oxide Passivated Contact in Front Surface for N-Type Poly-Si Based Passivated Contact Bifacial Solar Cells

An experimental investigation of spin-on doping optimization for enhanced electrical characteristics in silicon homojunction solar cells: Proof of concept

Simulation of a Silicon Heterojunction Solar Cell with a Gradient Doping Emitter Layer

Influence of Low Rate P/I Interface Layer on the Performance of High Growth Rate Microcrystalline Silicon Solar Cells

Study of Black Silicon Wafer through Wet Chemical Etching for Parametric Optimization in Enhancing Solar Cell Performance by PC1D Numerical Simulation

Doped Microcrystalline Silicon Layers for Solar Cells by 13.56 Mhz Plasma-Enhanced Chemical Vapour Deposition

Study on the Front Contact Mechanism of Screen-Printed Multi-Crystalline Silicon Solar Cells

Efficiency improvement of crystalline silicon solar cells with a back-surface field produced by boron and aluminum co-doping

Optimization of intrinsic layer thickness, dopant layer thickness and concentration for a-SiC/a-SiGe multilayer solar cell efficiency performance using Silvaco software

Simulation of Silicon Solar Cells with Passivation Contact of Tunnel Oxide Layer

An insight into effect of front surface field on the performance of interdigitated back contact silicon heterojunction solar cells

Numerical Simulations of IBC Solar Cells Based on Poly-Si Carrier-Selective Passivating Contacts