Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

Optimization of Heterojunction Back-Contact (HBC) Crystalline Silicon Solar Cell Based on Quokka Simulation

Systematic Modeling and Optimization for High‐Efficiency Interdigitated Back‐Contact Crystalline Silicon Solar Cells

Tuning of the Contact Properties for High-Efficiency Si/PEDOT:PSS Heterojunction Solar Cells

Silicon Rich Carbide As A Conductive Substrate For Si Qd Solar Cells

Computer simulation of a-Si/c-Si heterojunction solar cell with high conversion efficiency

Investigation of a-Si (N+)/c-Si (P) hetero-junction solar cell through AFORS-HET simulation

Simulation of a high-efficiency silicon-based heterojunction solar cell

Realization and Simulation of Interdigitated Back Contact Silicon Solar Cells with Dopant-Free Asymmetric Hetero-Contacts

Simulation of heterojunction solar cells based on p-type silicon wafer

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

Current Matching and Efficiency Optimization in a Two-Junction Nanowire-on-silicon Solar Cell

Optimization of Mono-Crystalline Silicon Solar Cell Devices Using PC1D Simulation

Simulation and experimental study of a novel bifacial structure of silicon heterojunction solar cell for high efficiency and low cost

Silicon Homo-Heterojunction Solar Cells: A Promising Candidate to Realize High Performance More Stably

Numerical Simulations of IBC Solar Cells Based on Poly-Si Carrier-Selective Passivating Contacts

Optimized Metallization for Interdigitated Back Contact Silicon Heterojunction Solar Cells

Modeling and simulation of heterojunction crystalline silicon solar cells with a nanocrystalline cubic silicon carbide emitter

Simulation of p-type c-Si solar cells with metal oxides as carrier-selective contacts

Nanocrystalline‐silicon hole contact layers enabling efficiency improvement of silicon heterojunction solar cells: Impact of nanostructure evolution on solar cell performance

Interdigitated back contact silicon heterojunction solar cell and the effect of front surface passivation

Dopant‐Free and Carrier‐Selective Heterocontacts for Silicon Solar Cells: Recent Advances and Perspectives