Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

Computer simulation of a-Si/c-Si heterojunction solar cell with high conversion efficiency

Hybrid heterojunction and photoelectrochemistry solar cell based on silicon nanowires and double-walled carbon nanotubes.

Simulation of a high-efficiency silicon-based heterojunction solar cell

Simulation of heterojunction solar cells based on p-type silicon wafer

Investigation of a-Si (N+)/c-Si (P) hetero-junction solar cell through AFORS-HET simulation

Simulation of High-Efficiency Crystalline Silicon Solar Cells with Homo–Hetero Junctions

RESEARCH ON 400cm2 a-Si/a-Si TANDEM SOLAR CELLS

Simulation and experimental study of a novel bifacial structure of silicon heterojunction solar cell for high efficiency and low cost

Simulation of High Conversion Efficiency and Open-circuit Voltages Of α-si/poly-silicon Solar Cell

Simulation of the Efficiency of a-SiC:H/a-Si:H Tandem Multilayer Solar Cells

Maximizing Conversion Efficiency: A Numerical Analysis on P+ a-SiC/i Interface/n-Si Heterojunction Solar Cells with AMPS-1D

Simulation of p-type c-Si solar cells with metal oxides as carrier-selective contacts

Silicon Homo-Heterojunction Solar Cells: A Promising Candidate to Realize High Performance More Stably

Optimization of Heterojunction Back-Contact (HBC) Crystalline Silicon Solar Cell Based on Quokka Simulation

From planar junction to local junction: A new structure design of amorphous/crystalline silicon heterojunction solar cells for high efficiency and low cost

Efficient Heterojunction Solar Cells on P-Type Crystal Silicon Wafers

Modeling and simulation of heterojunction crystalline silicon solar cells with a nanocrystalline cubic silicon carbide emitter

Simulation of a Silicon Heterojunction Solar Cell with a Gradient Doping Emitter Layer

Simulation of High Efficiency Silicon Heterojunction Solar Cells with Molybdenum Oxide Carrier Selective Layer

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

Simulation of a Charged Al2O3 Film as an Assisting Passivation Layer for a-Si Passivated Contact P-Type Silicon Solar Cells