Maximizing Conversion Efficiency: A Numerical Analysis on P+ a-SiC/i Interface/n-Si Heterojunction Solar Cells with AMPS-1D

Feroz Ali,Faruk Hossain,Alamgir Hossain,Md. Feroz Ali,Md. Faruk Hossain,Md. Alamgir Hossain

DOI: https://doi.org/10.1155/2024/6846310

2024-03-26

International Journal of Photoenergy

Abstract:In this study, a heterojunction (P+ a-SiC/i intrinsic/n-Si) solar cell has been examined and characterized using the Analysis of Microelectronics and Photonic Structures (AMPS-1D) simulator. In this heterojunction solar cell, an intrinsic layer is imposed to enhance the efficiency and performance. The optimum efficiency of 36.52% ( Voc=1.714 V, Jsc=27.006 mA/cm2, and FF=0.789 ) has been achieved with this intrinsic layer. It has also been observed the solar cell without intrinsic layer. In this case, the maximum efficiency of 2.378% has been observed which is very poor. The heterojunction solar cell also has been investigated with electron blocking layer (EBL) and defect layer. In this case, the simulation result shows the lower efficiency (34.357%) than the previous. This research paper introduces an optimized model of a heterojunction solar cell enhanced with an intrinsic layer to improve efficiency. The proposed design shows significant promise in its theoretical framework. Looking forward, the design could be realized in laboratory settings and has the potential to be scaled up for broader applications.

energy & fuels,chemistry, physical,optics,physics, atomic, molecular & chemical

What problem does this paper attempt to address?

The paper primarily aims to address the limited efficiency of silicon-based heterojunction solar cells, particularly by introducing an intrinsic layer to improve the cell's conversion efficiency. Specifically, the study focuses on the following points:

1. **Impact of the Intrinsic Layer**: By adding an undoped intrinsic layer between the P-type doped silicon carbide (P+a-SiC) and N-type silicon (n-Si), the study aims to reduce carrier recombination, thereby enhancing the overall efficiency of the solar cell.

2. **Optimization of Design Parameters**: The research explores the impact of different design parameters on cell performance, including the bandgap and thickness of the intrinsic layer, P+a-SiC layer, and n-Si layer, as well as key factors like carrier concentration.

3. **Simulation Tools**: The study utilizes AMPS-1D simulation software for one-dimensional device analysis. By adjusting parameters such as grid spacing, the research examines how these factors affect the cell's open-circuit voltage (Voc), short-circuit current density (Jsc), fill factor (FF), and conversion efficiency.

4. **Determination of Optimal Parameters**: Based on the simulation results, the study identifies the optimal combination of design parameters. For example, the optimal bandgap for the intrinsic layer is 2.7 eV, with an optimal thickness of 8000 nanometers; the optimal bandgap for the P+a-SiC layer is 2.2 eV, among other parameters.

5. **Performance Comparison**: The paper also compares the performance of solar cells without an intrinsic layer and other configurations (such as those including electron blocking layers and defect layers) to highlight the importance of the intrinsic layer in improving efficiency.

In summary, this paper aims to reveal the potential of the intrinsic layer in enhancing the efficiency of silicon-based heterojunction solar cells through theoretical simulations and to explore the optimal design parameters, laying the foundation for future experimental research and practical applications.