Abstract:Process variations during manufacturing lead to differences in the performance of the chips. In order to better utilize the performance of the chips, it is necessary to perform maximum operation frequency (Fmax) tests to place the chips into different speed bins. For most Fmax tests, significant efforts are put in place to reduce test cost and improve binning accuracy; e.g., our conference paper published in ICICM 2017 presents a novel binning sensor for low-cost and accurate speed binning. However, by promoting chips placed at the lower bins, because of conservative binning, into higher bins, the overall profit can greatly increase. Therefore, this paper, extended based on a conference paper, presents a novel and adaptive methodology for speed binning, in which the paths impacting the speed bin of a specific IC are identified and adapted by our proposed on-chip Binning Checker and Binning Adaptor. As a result, some parts at a bin margin can be promoted to higher bins. The proposed methodology can be used to optimize the Fmax yield of a digital circuit when it has redundant timing in clock tree, and it can be integrated into current Fmax tests with low extra cost. The proposed adaptive system has been implemented and validated on five benchmarks from ITC, ISCAS89, and OpenSPARCT2 core on 28 nm Altera FPGAs. Measurement results show that the number of higher bin chips is improved by 7-16%, and our cost analysis shows that the profit increase is between 1.18% and 3.04%.

A BIST Scheme for High-speed Gain Cell Edram

An Effective BIST Circuit for Barrel Shifter Within 8 Bits MCU

Gain Cell eDRAM Design with Stagger Hidden Refresh Scheme

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

Design and Test of the In-Array Build-In Self-Test Scheme for the Embedded RRAM Array

An In-Array Build-In Self-Test Scheme for Embedded SRAM Array

A logic 2T gain cell eDRAM with enhanced retention and fast write scheme

Novel 2T gain cell with enhanced retention time for embedded DRAM application

A novel layout automation flow to facilitate test chip design for standard cell characterization

A 390-mm/sup 2/, 16-bank, 1-Gb DDR SDRAM with hybrid bitline architecture

A Power Efficient BIST TPG Method on Don't Care Bit Based 2-D Adjusting and Hamming Distance Based 2-D Reordering

Built-In Self-Test Architecture Enabling Diagnosis for Massive Embedded Memory Banks in Large SoCs

A 512 Kb SRAM in 65nm CMOS with Divided Bitline and Novel Two-Stage Sensing Technique

On-Chip Structures for Fmax Binning and Optimization

Efficient built-in self-repair strategy for embedded SRAM with selectable redundancy

Design Guidelines for Oxide Semiconductor Gain Cell Memory on a Logic Platform

A control scheme for a 65nm 32×32b 4-read 2-write register file

BILBO-friendly Hybrid BIST Architecture with Asymmetric Polynomial Reseeding

A Multi-frequency BIST IP Core with Scan Chain for Embedded Register File

A Novel 1T-DRAM Fabricated with 22 nm FD-SOI Technology

An eDRAM with Logic Technology Using High-Speed R/W and Compact Charge Transfer Refresh Scheme