Abstract:Recently, carbon nanotube field-effect transistors (CNTFETs) have garnered significant attention from VLSI engineers due to their exceptional electrical properties. This paper proposes a novel high-speed, low-power eight-transistor (8 T) static random-access memory (SRAM) cell based on 32-nm CNTFET technology. The SRAM cell was simulated using the HSPICE tool with a V DD of 0.9 V. The high-speed and low-power characteristics of the SRAM design are attributed to the high subthreshold slope and high carrier mobility of metal-oxide-semiconductor field-effect transistor (MOSFET)-like CNTFETs utilized in the simulations. The implementation of dual threshold transistors, coupled with a transmission gate for bitline access, contributes to the enhanced performance. Key performance metrics such as noise margins, power consumption, delay, and SRAM electrical quality metric (SEQM) of the proposed SRAM have been evaluated and compared with existing CNTFET-based SRAM designs. The proposed cell demonstrates reductions of 73.73%, 43.18%, and 58.70% in read power, write power, and hold power, respectively, compared to the lowest respective power values of other examined SRAM designs. The proposed SRAM ranks second, third, and second in write static noise margin (WSNM), hold static noise margin (HSNM), and read static noise margin (RSNM), respectively, among other designs. Additionally, the proposed SRAM exhibits the least sensitivity to parametric variations compared to other designs. The SEQM, which provides a comprehensive assessment of access times, noise margins, and power usage for the SRAM cell, has been calculated. The SEQM of the proposed SRAM is 10.6, 1.89, 13.15, and 1.82 times higher than that of C6T, BLP8T, Mani's 10 T, and LP8T, respectively.

A 512 Kb SRAM in 65nm CMOS with Divided Bitline and Novel Two-Stage Sensing Technique

Bit-Interleaving-Enabled 8t Sram with Shared Data-Aware Write and Reference-Based Sense Amplifier

Design of 512-Kbit Synchronous High-speed SRAM

Performance Improvements by SL-Current Limiter and Novel Programming Methods on 16MB RRAM Chip

Sensing Circuit Design Techniques for RRAM in Advanced CMOS Technology Nodes

Design of the Two-Tier MUX in 65 Nm SRAM

3D SRAM Using Ultrathin Body Nanosheets and Bitline Signal Decoupling

Design analysis of a low-power, high-speed 8 T SRAM cell using dual-threshold CNTFETs

-Memory Computing Based Reliable and High Speed Schmitt trigger 10T SRAM cell design

Design of High-Speed SRAM Array and Peripheral Circuits for Compiler

An Area-Efficient Dual Replica-Bitline Delay Technique For Process-Variation-Tolerant Low Voltage Sram Sense Amplifier Timing

A Novel Test Methodology For Design Of An Embedded Synchronous Dual-Read/Write Port Sram With Configurable Capacity

A logic 2T gain cell eDRAM with enhanced retention and fast write scheme

Two-Direction In-Memory Computing Based on 10T SRAM With Horizontal and Vertical Decoupled Read Ports

An 8kb 40-Nm 2T2MTJ STT-MRAM Design with 2.6ns Access Time and Time-Adjustable Writing Process

A Current Mode Sense Amplifier with Self-Compensation Circuit for Sram Application

An innovative sensing architecture for multilevel Flash memory

A low-Power SRAM with charge cycling based read and write assist scheme

A near-threshold SRAM design with transient negative bit-line voltage scheme

A Single Bitline Highly Stable, Low Power With High Speed Half-Select Disturb Free 11T SRAM Cell

A 28nm 1.5mb Embedded 1T2R RRAM with 14.8 Mb/mm2 Using Sneaking Current Suppression and Compensation Techniques