Abstract:Surface acoustic waves (SAWs) are of practical importance across several fields. Particularly, a wide range of SAW devices is available, which are based on the stacking piezoelectric layered hetero-structures. As such, efficient and stable algorithm of analyzing electromechanical coupling factor (K2) should be of specific interest, inspiring a variety of piezoelectric layered structures. Motivated by the above considerations, this paper exploits the performance of Sc43% AlN57%/ZnO/diamond piezoelectric hetero-structures using matrix and polynomial methods. Consequently, dispersion curves, the electromechanical coupling factor and profiles of Rayleigh waves are calculated, in which the properties of hexagonal intermediate ZnO layer are varied. Here, $$ (0001) - [10\bar{1}0]{\text{ZnO}} $$ or $$ (11\bar{2}0) - [0001]{\text{ZnO}} $$ directions of the middle layer were integrated with Sc43% AlN57%/diamond to be a composite hetero-structure with a larger K2 of SAW. Accordingly, a commercial ZnO specimen was characterized by scanning electron microscopy (SEM) as well as Raman and XRD spectroscopy to determine its available crystallographic directions and the C-axis hexagonal character. Comparing with conventional AlN/diamond hetero-structures, the inclusion of ZnO as the intermediate layer provides with an excellent electromechanical coupling factor which significantly improves the $$ (11\bar{2}0) - [0001] $$ structure. However, comparing with the ZnO/diamond hetero-structure, a high phase velocity (Vph) was observed. Therefore, the development of a well-balanced structure that maximizes the values of Vph and K2 is systematically challenging. Moreover, it was found that initial stresses have a significant effect on the Rayleigh wave velocities. Fundamental A0 Lamb mode can be generated in piezoelectric hetero-structures when the properties of substrate remain very low relative to the film. Numerical results obtained in this paper can provide a deeper insight into the nature of the Rayleigh wave behaviors in piezoelectric hetero-structures, involving a ZnO intermediate layer.

Ultra flexible pseudo-lamb wave RF resonators based on ZnO/PI and AlN/PI structures

Flexible structured high-frequency film bulk acoustic resonator for flexible wireless electronics

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Broad tuning low noise ku band dielectric resonators oscillators

Enhanced Performance Of Zno/Sio2/Al2o3 Surface Acoustic Wave Devices With Embedded Electrodes

Enhanced Performance of ZnO/SiO 2 /Al 2 O 3 Surface Acoustic Wave Devices with Embedded Electrodes

High-Frequency Surface Acoustic Wave Devices Based on ZnO/SiC Layered Structure

Fundamental Antisymmetric Mode Acoustic Resonator in Periodically Poled Piezoelectric Film Lithium Niobate

Flexible Surface Acoustic Wave Device with Aln Film on Polymer Substrate

High Electromechanical Coupling Factor Lamb Wave Resonator

Flexible surface acoustic wave resonators built on disposable plastic film for electronics and lab-on-a-chip applications

Influence of a Piezoelectric ZnO Intermediate Layer on Rayleigh Waves Propagating in Sc 43% AlN 57% /zno/diamond Hetero-Structures Subjected to Uniaxial Stress

Surface acoustic wave resonators based on (002)AlN/Pt/diamond/silicon layered structure

Crystalline Structure Effect on the Performance of Flexible ZnO/polyimide Surface Acoustic Wave Devices

Solidly Mounted Resonators with Ultra‐High Operating Frequencies Based on 3R‐MoS2 Atomic Flakes

LITHIUM NIOBATE THIN FILM BASED A1 MODE RESONATORS WITH FREQUENCY UP TO 16 GHZ AND ELECTROMECHANICAL COUPLING FACTOR NEAR 35%

Thin Film Flexible/bendable Acoustic Wave Devices: Evolution, Hybridization and Decoupling of Multiple Acoustic Wave Modes

High Figure-of-Merit A1-Mode Lamb Wave Resonators Operating Around 6 GHz Based on the LiNbO3 Thin Film

A flexible, gigahertz, and free-standing thin film piezoelectric MEMS resonator with high figure of merit

Monolithic 1–6-Ghz Multiband Acoustic Filters Using SH-SAW and LLSAW on LiNbO$_{3}$/SiO$_{2}$/SiC Platform

Three-Dimensional Finite Element Analysis and Characterization of Quasi-Surface Acoustic Wave Resonators