Abstract:Distinct from the conventional double‐balanced mixer topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. This paper introduces a downconverter mixer employing a modified double‐balanced Gilbert‐cell topology, designed using IHP's 0.13‐μ m SiGe BiCMOS technology. Distinct from the conventional topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. The LO and IF differential signals are converted to single‐ended ones through transformer baluns for measurement purposes. The frequencies of operation for RF, LO, and IF are 24–30, 18–24, and 6 GHz, respectively. The conversion loss is 7.7 dB at 26 GHz, with port‐to‐port isolations exceeding 35 dB. The input 1‐dB compression point is 5.7 dBm, while the circuit consumes 65‐mW power from a 3.3‐V voltage supply. Excluding the pads, the active area of the design spans 1 mm2.

12 GHz Monolithic Double-Balanced Down Converter in 65 Nm CMOS

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

Photonic Down-Conversion and Linearisation with Tunable IF Bandwidth and Improved Spurious-Free Dynamic Range

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 30-60 GHz Broadband Low LO-Drive Down-Conversion Mixer with Active IF Balun in 65 nm CMOS Technology

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

A 24‐ghz Active Up/down Bidirectional Mixer in 130‐nm RF CMOS

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A Gm-boosted and current peaking wideband merged LNA and mixer

A 0.18um 3.3mw Double-Balanced CMOS Active Mixer

A 24-to-30 GHz Ultra-High-Linearity Down-Conversion Mixer for 5G Applications Using a New Linearization Method

A 10ghz 2.8db Gain Passive Mixer In 0.18um Cmos Technology

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

A CMOS down-conversion micromixer for IEEE 802.11b WLAN transceivers

Design and Realization of a 2 GHz Downconversion Mixer

A Complementary Current-Mirror-Based Bulk-Driven Down-Conversion Mixer for Wideband Applications

A 24–30‐GHz Modified Gilbert‐Cell Downconverter With High Linearity and Isolation

A 900mhz High Linearity Low Power Down-Conversion Mixer

A 1.9 GHz High Linearity CMOS Up-mixer

2.4 GHz 0.35μm CMOS gilbert down-conversion mixer