Abstract:Distinct from the conventional double‐balanced mixer topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. This paper introduces a downconverter mixer employing a modified double‐balanced Gilbert‐cell topology, designed using IHP's 0.13‐μ m SiGe BiCMOS technology. Distinct from the conventional topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. The LO and IF differential signals are converted to single‐ended ones through transformer baluns for measurement purposes. The frequencies of operation for RF, LO, and IF are 24–30, 18–24, and 6 GHz, respectively. The conversion loss is 7.7 dB at 26 GHz, with port‐to‐port isolations exceeding 35 dB. The input 1‐dB compression point is 5.7 dBm, while the circuit consumes 65‐mW power from a 3.3‐V voltage supply. Excluding the pads, the active area of the design spans 1 mm2.

2.4 GHz 0.35μm CMOS gilbert down-conversion mixer

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A group-selected and gain controllable CMOS active mixer for UWB applications

A 0.18 Mu M Cmos High Linearity Flat Conversion Gain Down-Conversion Mixer For Uwb Receiver

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

A 0.18μm CMOS high linearity flat conversion gain down-conversion mixer for UWB receiver

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

An Implementation of a CMOS Down-Conversion Mixer for GSM1900 Receiver

Optimizing Mixer Noise Performance: A 2.4 Ghz Gilbert Downconversion Mixer for W-Cdma Application

Low Voltage CMOS Gilbert Mixers for Bluetooth Transceiver

A 24‐ghz Active Up/down Bidirectional Mixer in 130‐nm RF CMOS

Design and Realization of a 2 GHz Downconversion Mixer

A 0.18um 3.3mw Double-Balanced CMOS Active Mixer

A 24–30‐GHz Modified Gilbert‐Cell Downconverter With High Linearity and Isolation

A 27.5–43.5 GHz High Linearity Up-Conversion CMOS Mixer for 5G Communication

A New Low Voltage RF CMOS Mixer Design

CMOS Mixers for 2.4GHz WLAN Transceivers

Design of a 24-30-GHz High-Linearity Down-Conversion Mixer

A 0.18μm CMOS Gilbert low noise mixer with noise cancellation