Abstract:Distinct from the conventional double‐balanced mixer topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. This paper introduces a downconverter mixer employing a modified double‐balanced Gilbert‐cell topology, designed using IHP's 0.13‐μ m SiGe BiCMOS technology. Distinct from the conventional topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. The LO and IF differential signals are converted to single‐ended ones through transformer baluns for measurement purposes. The frequencies of operation for RF, LO, and IF are 24–30, 18–24, and 6 GHz, respectively. The conversion loss is 7.7 dB at 26 GHz, with port‐to‐port isolations exceeding 35 dB. The input 1‐dB compression point is 5.7 dBm, while the circuit consumes 65‐mW power from a 3.3‐V voltage supply. Excluding the pads, the active area of the design spans 1 mm2.

A 24–30‐GHz Modified Gilbert‐Cell Downconverter With High Linearity and Isolation

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 24‐ghz Active Up/down Bidirectional Mixer in 130‐nm RF CMOS

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

Design of a 24-30-GHz High-Linearity Down-Conversion Mixer

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 24-to-30 GHz Ultra-High-Linearity Down-Conversion Mixer for 5G Applications Using a New Linearization Method

Compact CMOS Baluns for the 4–10 GHz Band Applications

A double-balanced down converter mixer in GaN-on-Si HEMT technology

2.4 GHz 0.35μm CMOS gilbert down-conversion mixer

A 30-60 GHz Broadband Low LO-Drive Down-Conversion Mixer with Active IF Balun in 65 nm CMOS Technology

Modified Broadband Ruthroff-Type Transmission Line Transformer Balun for Isolation-Enhanced Passive Mixer Design

High-Linearity Double-Balanced Up-Conversion Mixer with an Active Balun Based on InGaP/GaAs HBT Technique

A 27.5–43.5 GHz High Linearity Up-Conversion CMOS Mixer for 5G Communication

12 GHz Monolithic Double-Balanced Down Converter in 65 Nm CMOS

A 62–85-Ghz High Linearity Upconversion Mixer with 18-Ghz IF Bandwidth

A High Performance Double-Balanced Gilbert Mixer with Active Loads for 2.4-GHz ISM Band Application

Design and Analysis of a Reconfigurable Gilbert Mixer for Software-Defined Radios

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

A Reusable Superheterodyne Dual-Band Down-Conversion Mixer With Hybrid Linearity-Enhanced Technique for 5G Non-Contiguous Multiband NR

A 0.18um 3.3mw Double-Balanced CMOS Active Mixer