Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A Low Power 45-Db DR All-Digital Assisted AGC Loop for a GNSS Receiver in 0.18 Um CMOS

A 2-Mw 50-Db DR Wideband Hybrid AGC for a GNSS Receiver in 65 Nm CMOS

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 49-dB DR wide locking range hybrid AGC for an ISM-band receiver in 0.18 um CMOS

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A Linear-in-Decibel Automatic Gain Control Amplifier with Dual Mode Continuous Gain Tuning

A 28 GHz LNA using defected ground structure for 5G application

Design of variable loop bandwidth high sensitivity micro-satellite receiver

A Low-Power High-Data-Rate ASK IF Receiver with a Digital-Control AGC Loop

A Low Power Programmable Gain Amplifier for Multi-mode Receiver

High-speed and low-complexity analog automatic gain control loop for UWB receiver

A Low-Power PGA with DC-Offset Cancellation in 65 Nm CMOS Process

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A Novel Low Power ASK Receiver with AGC Loop

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop