Abstract:This study presents a low-power Zigbee receiver with a current-reusing structure and function-reused mixing techniques. To reduce the overall power consumption, a low noise amplifier (LNA) and a power amplifier (PA) share the biasing current with a voltage-controlled oscillator (VCO) in the receiving (RX) mode and transmitting (TX) mode, respectively. The function-reused mixer reuses the radio frequency trans-conductance (RF gm) stage to amplify the down-converted intermediate frequency (IF) signal, obtaining a free IF gain without extra power consumption. A peak detector circuit detects the receiving signal strength and auto-adjusts the biasing current to save power when a strong signal strength is detected. Meanwhile, the peak detector helps to provide a coarse gain control as part of the auto-gain-control function. As part of the IF gain range is shared by the multiple-feedback (MFB) low-pass filter, the number of programmable-gain IF amplifier stages can be reduced, which also means a decrease in power consumption. A prototype of this wireless sensor network (WSN) receiver was designed and fabricated using the TSMC 130 nm CMOS process under a supply voltage of 1 V. The entire receiver realizes a noise figure (NF) of 3.5 dB and a receiving sensitivity of −90 dBm for the 0.25 Mbps offset quadrature phase shift keying (O-QPSK) signal with a power consumption of 2.9 mW.

A Novel Low Power ASK Receiver with AGC Loop

A Low-Power High-Data-Rate ASK IF Receiver with a Digital-Control AGC Loop

A receiver analog front-end for body sensor network

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

An ASK-Based IF Receiver for Wireless Endoscopy Capsule Systems

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

Novel Low-Voltage / Low-Power ASK Demodulator for RFID Tags

A Wideband and Low Power Dual-Band ASK Transceiver for Intra/inter-Chip Communication

A High-Performance ASK Demodulator for Wireless Recovery System

A Low-power ASK Demodulator for Wireless Power and Data Transfer Systems Supporting Ultra-low Modulation Depth of 0.03%.

A Low Power 45-Db DR All-Digital Assisted AGC Loop for a GNSS Receiver in 0.18 Um CMOS

A low power self-sampling IF FSK receiver

A low-power IF circuit with 5-dB minimum input SNR for GFSK low-IF receivers

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

A Low-Power DC Offset Calibration Method Independent of IF Gain for Zero-if Receiver.

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

An Ultra Low Power ASK Demodulator for Passive UHF RFID Tag