Abstract:This article presents a 915-MHz ultra-low-power (ULP) sub-sampling phase-tracking receiver (SSPT-RX). It is targeted for the power-constrained devices that need short range but medium high-speed data receiving, such as the multi-channel neural stimulator with arbitrary waveform generation. The zero-intermediate frequency (zero-IF) phase-tracking receiver (PT-RX) topology is adopted to simplify the sub-sampling RX architecture with direct demodulation of frequency-shift keying (FSK) signal while improving the image frequency issue. The frequency of local oscillator (LO) is reduced by ten times with the proposed architecture, which leads to greatly reduced power consumption. Fabricated in 65-nm CMOS process, the RX chip occupies an active area of 0.58 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . The RX consumes one of the lowest power consumptions of 164 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{W}$ </tex-math></inline-formula> from 0.5-/1-V supplies. It achieves an energy efficiency of 32.8 pJ/bit at a data rate of 5 Mb/s, which is improved by <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\sim 5.6\times $ </tex-math></inline-formula> compared to the state-of-the-art RXs. The measured sensitivity of 915-MHz FSK signal receiving is −69.5 dBm with an LO frequency of 91.5 MHz, which is 1/10 of the carrier frequency. The achieved RX sensitivity figure-of-merit (FoM) is 174.3 dB.

A low-power IF circuit with 5-dB minimum input SNR for GFSK low-IF receivers

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

The Design And Implement Of A Receiver For Fsk Signal

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A Low-Power Robust GFSK Demodulation Technique for WBAN Applications

A Low-Power All-Digital GFSK Demodulator with Robust Clock Data Recovery.

A Low-Power High-Data-Rate ASK IF Receiver with a Digital-Control AGC Loop

A Low-Power Digital Gfsk Receiver With Mid-Value Filtering Frequency Offset Estimator And Soft Anti-Overlap Slicer

A low power self-sampling IF FSK receiver

A 0.18- $\mu\hbox{m}$ CMOS GFSK Analog Front End Using a Bessel-Based Quadrature Discriminator with On-Chip Automatic Tuning

A 7.9 Μa Multi-Step Phase-Domain ADC for GFSK Demodulators

An 89 Μw MICS/ISM Band Receiver for Ultra-Low-power Applications.

A Low-Power Low-Noise 600mhz CMOS IF Demodulator for Superheterodyne Receivers.

2.4Ghz 20mb/s FSK Receiver Front-End and Transmitter Modulation PLL Design for Energy-Efficient Short-Range Communicaiton

A Low-Power Fast-Settling Bond-Wire Frequency Synthesizer with a Dynamic-Bandwidth Scheme

A 164-$\mu$ W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications