Abstract:A wideband high dynamic range software radio receiver for sub-6-GHz applications is proposed. The receiver combines three gain variable modules and an automatic gain control module to achieve high gain dynamic range and constant output voltage. A broadband resistive feedback LNA was designed, and two novel gain switching methods were proposed for the resistive feedback LNA, which reduced the LNA gain while optimizing the input matching performance. In addition, the receiver adopts a voltage mode mixer and uses the impedance translation property to achieve blocker-tolerant performance. In analog baseband (ABB), a fourth-order Butterworth active-RC low-pass filter (LPF) is employed for the purpose of attenuating interference. Furthermore, the receiver is furnished with an automatic gain control amplifier to uphold a consistent output voltage amplitude. A 22 nm CMOS receiver prototype occupies 1.85 mm(2) and consumes 51 mW from a 1 V power supply over the 2-6 GHz operating frequency range. The receiver achieves a gain dynamic range of 9.1-91.9 dB and a noise figure (NF) of 2.4-3.4 dB. When a 0 dBm blocker with a frequency offset of 80 MHz is injected into the receiver, the NF increases to 13.2 dB. The programmable bandwidth of the LPF can be adjusted from 10 to 160 MHz. Moreover, the receiver achieved an in-band third-order input-referred intercept point (IIP3) of - 9.1 dBm and an out-of-band IIP3 of - 2.9 dBm respectively.

Design of variable loop bandwidth high sensitivity micro-satellite receiver

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

Implementation of a New S-Band Micro-Transponder Based on Software Defined Radio

A New Receiver Structure of TT&C Transponder for Pico-Satellite

Carrier Recovery Loops in All-digitized QAM Receiver

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

Study on the Tracking Accuracy of Regenerative Ranging Codes Used in Micro-Satellite Transponders

A new implementation of S-band TT&C transponder for micro-satellites

Design and Simulation of Low-Orbit Satellite Broadcast Signal Receiving and Processing Terminal

A 2–6 GHz Reconfigurable High Dynamic Range Receiver with Wideband Variable Gain LNA

Design and simulation of coherent Automatic Gain Control for TT&C receivers

An E Band Wideband Superheterodyne Receiver Front-End Using Large-Dynamic-Range Automatic-Gain-Control Loop

Design and Implementation of Digital IF Telemetry Receiver

Design of a General-Purpose Wideband FM Demodulation Circuit

A 2-Mw 50-Db DR Wideband Hybrid AGC for a GNSS Receiver in 65 Nm CMOS

A high-sensitivity GPS receiver carrier-tracking loop design for high-dynamic applications

A High-Gain Dual-Band and Dual-Polarized Transmitarray Using Novel Loop Elements

A Ku-Band Broadband High-IF Receiver with Wide Input Dynamic Range in 65-Nm CMOS

Wide Baseband Analog AGC System with Large Dynamic Range Based on Peak Power Detection