Abstract:Electronic packages are often exposed to complex life cycle environments, and in many cases, that involves exposure to multiaxial vibration. Previous studies have shown that under moderate or high amplitude multiaxial vibration, electronic systems can experience nonlinear response, especially for heavy components with high stand-off. This can produce cross-axis nonlinear interactions, resulting in amplification (or cancellation) of the nonlinear response, in comparison to the responses to uniaxial excitation along orthogonal axes. This nonlinear interaction has obvious implications on vibration durability of the assembly. The study performs a parametric combination of uniaxial and multiaxial vibration testing and modelling on structures that are mechanically equivalent to tall heavy electronic components, with varying loading parameters. Mechanical beams are designed as scaled surrogates to represent the dynamical behavior of Printed Circuit Boards (PCBs) with tall and heavy components on it. To investigate the nonlinear effects of multiaxial vibration excitation under different loading conditions, mechanical beams of different mass and length have been tested under different excitation profiles. The result shows that multiaxial vibration excitation can produce significant amounts of nonlinear cross-axis interactions, thus raising questions about the effectiveness of the traditional methodology of superposition of uniaxial vibration excitation for PWAs. The severity of nonlinear response depends not only on excitation parameters such as frequency ratios, phase relationships and amplitudes, but also on the component architecture. The resulting crossaxis interaction increases as the component becomes taller and heavier, which shows correlation between the size of the component and the nonlinearity of the vibrational response. The findings of this study will provide important guidance for developing protocols for multiaxial vibration testing instead of sequential uniaxial vibration testing.

Research on nonlinear vibration in micro-machined resonant accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Nonlinear Vibration Study Based on Uncertainty Analysis in MEMS Resonant Accelerometer

A New Type of MEMS Accelerometer with Up-Tuning Structure

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Design and Test of a Micromachined Resonant Accelerometer with High Scale Factor and Low Noise

Nonlinear Analysis for Micromachined Accelerometer Based on Resonant Principle

Low-Noise Drive of a Micromachined Resonant Accelerometer with Separated Sensing and Actuation

MICRO-VIBRATION SUPPRESSION OF EQUIPMENT SUPPORTED ON A SANDWICH BEAM INCORPORATING MAGNETO-RHEOLOGICAL ELASTOMER (MRE) CORE

A New Analytical Model of Single-Stage Microleverage Mechanism in Resonant Accelerometer

Nonlinear Dynamic Characteristics of Magneto-Rheological Visco-Elastomers

Effect of Nonlinear Interactions of Electronic Assemblies in Response to Multiaxial Vibration

Structural Design and Testing of a Micromechanical Resonant Accelerometer

Critical Technologies in Design of Micromechanical Resonant Accelerometer

Design and Optimization of the Resonator in a Resonant Accelerometer Based on Mode and Frequency Analysis

Nonlinear support loss in micro/nano beam resonators induced by geometric nonlinearity

Bulk-Micromachined Silicon Resonant Accelerometer

On Extending Signal-to-Noise Ratio of Resonators for a MEMS Resonant Accelerometers Using Nonlinearity Compensation

Research on nonlinear response analysis of micro-cracks under vibro-acoustic modulation.

Nonlinear tuning of microresonators for dynamic range enhancement

A Compensation Method for Nonlinear Vibration of Silicon-Micro Resonant Sensor