Abstract:In some circumstances, hybrid polymer microfluidic chips composed of both elastic, gas-permeable polydimethylsiloxane (PDMS) and rigid plastics are needed. However, it is quite difficult to bond PDMS irreversibly to plastics such as polystyrene (PS). In this article, a facile method for irreversible bonding of PDMS to PS was proposed based on UV/O-3-assisted surface modification in combination of surface silanization. Firstly, a PS sheet was exposed to UV/O-3 to produce oxygen-containing polar moieties, such as hydroxyl and carboxylic acid, on its surface. Secondly, the UV/O-3 treated PS sheet was silanized with (3-aminopropyl)triethoxysilane (APTES) via the reaction between the oxygen-containing polar moieties on the PS surface and the molecules of APTES. Thirdly, the silanized-PS sheet and the PDMS substrate with micro channel network were treated with UV/O-3 again to generate silanol moieties on both surfaces. Finally, the UV/O-3 treated PDMS was immediately brought intimate contact with the UV/O-3 treated silanized-PS, and irreversible bonding of PDMS with PS occurred after putting the PDMS-PS complex at room temperature for 1 h through the condensation reaction between silanol moieties. Contact angle measurement, X-ray photoelectron spectroscopy, total reflection Fourier transformation infrared spectrometer were applied to characterize the surface chemistry of the PS during the UV/O-3 treatment and silanization. The hybrid PDMS-PS microfludic chips prepared with the established method can bear a gas pressure higher than 0.5 MPa and a water stream at a flow rate higher than 170 mu L/min (the test channels were 2.5 cm in the length, 50 mu m in the width, 200 mu m in the depth). A hybrid PDMS-PS microfluidic chip composed of gas-permeable PDMS substrate with channel network and excellently biocompatible PS cover sheet was fabricated for cell culture. The experimental results showed that HeLa cells cultured in the hybrid PDMS-PS microchip grew much better than those cultured in the full PS microchip, and slightly better than those in the full PDMS microchip.

Fabrication of PDMS Microfluidic Chip Used in Ultraviolet Integrated Biological Chip

Novel Fabrication Technology Of Polydimethylsiloxane Microfluidic Chip

Fabrication of a Three-Layer PDMS Pneumatic Microfluidic Chip for Micro Liquid Sample Operation

Fabrication of Fluidic Chips with 1-D Nanochannels on PMMA Substrates by Photoresist-Free UV-lithography and UV-assisted Low-Temperature Bonding

Fabrication and Numerical Analysis of PDMS Micromixer on Microfluidic Chip

Fast fabrication of PDMS microfluidic electrophoresis chip

Fabrication of the PDMS-Glass Microfluidic Chip with Integrated Electrodes

Fabrication Of Microfluidic Chip And Its Application

A Low-Cost Method of Fabricating Hybrid Micro-Nano Fluidic Chip by Double-Layer PDMS Mold and UV–thermal Nanoimprinting

Fabrication of 1-d nanochannels on PMMA substrate by photoresist-free uv lithography and UV-assisted bonding under low temperature

Observation Interface of PDMS Membrane in a Microfluidic Chip Based on One-Step Molding

PDMS Molding Technology Using in Extract Typical Characteristic in Microfluidic-Chip

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Fabrication of PDMS Microfluidic Chips Used in Rapid Diagnosis by Micro Jetting

Surface Modification of Poly(dimethylsiloxane)-fabricated Microfluidic Chip by UV Radiation

Reasearch and fabrication of integrated pneumatic microvalves in polymer microfluidic chip

The microfluidic chip fabricated by Hot Embossing Lithography for single- microsphere test

An Approach for Irreversible Bonding of PDMS-PS Hybrid Microfluidic Chips at Room Temperature

A simple method for fabricating multi-layer PDMS structures for 3D microfluidic chips

Fabrication Of Microfluidic Chips By An Ultrasonic Micromachining With Wet-Etch Smoothing Method On Glass Substrates

Fabrication of Micro Pneumatic Valves with Double-Layer Elastic Poly(dimethylsiloxane) Membranes in Rigid Poly(methyl Methacrylate) Microfluidic Chips