Abstract:Since the monumental work conducted by Whitesides et al. in 2007, research and development of paper-based microfluidics has been widely carried out, with its applications ranging from chemical and biological detection and analysis, to environmental monitoring and food-safety inspection. Paper-based microfluidics possesses several competitive advantages over other substrate materials, such as being simple, inexpensive, power-free for fluid transport, lightweight, biodegradable, biocompatible, good for colorimetric tests, flammable for easy disposal of used paper-based diagnostic devices by incineration, and being chemically modifiable. Myriad methods have been demonstrated to fabricate paper-based microfluidics, such as solid wax printing, cutting, photolithography, microembossing, etc. In this study, fabrication of paper-based microfluidics was demonstrated by spray on the printed paper. Different from the normally used filter papers, printing paper, which is much more accessible and cheaper, was utilized as the substrate material. The toner was intended to serve as the mask and the patterned hydrophobic barrier was formed after spray and heating. The processing parameters such as toner coverage on the printing paper, properties of the hydrophobic spray, surface properties of the paper, and curing temperature and time were systematically investigated. It was found that, after repetitive printing four times, the toner was able to prevent the hydrophobic spray (the mixture of PDMS and ethyl acetate) from wicking through the printing paper. The overall processing time for fabrication of paper-based microfluidic chips was less than 10 min and the technique is potentially scalable. Glucose detection was conducted using the microfluidic paper-based analytical devices (μPADs) as fabricated and a linear relationship was obtained between 1 and 10 mM.

Fabrication of PDMS Microfluidic Chips Used in Rapid Diagnosis by Micro Jetting

Fabrication of a Three-Layer PDMS Pneumatic Microfluidic Chip for Micro Liquid Sample Operation

A Low-Cost Method of Fabricating Hybrid Micro-Nano Fluidic Chip by Double-Layer PDMS Mold and UV–thermal Nanoimprinting

A Simple and Low-Cost Method for Fabrication of Polydimethylsiloxane Microfludic Chips.

Observation Interface of PDMS Membrane in a Microfluidic Chip Based on One-Step Molding

Novel Fabrication Technology Of Polydimethylsiloxane Microfluidic Chip

Fabrication of Microfluidic Chips Based on an EHD-Assisted Direct Printing Method

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Design and fabrication of a PDMS microchip based immunoassay

A Simple Method For Fabrication Of Microstructures Using A Pdms Stamp

A low-cost and rapid microfluidic paper-based analytical device fabrication method: flash foam stamp lithography

Fast fabrication of PDMS microfluidic electrophoresis chip

A simple method for fabricating multi-layer PDMS structures for 3D microfluidic chips

The microfluidic chip fabricated by Hot Embossing Lithography for single- microsphere test

A Silicon-Based PDMS-PEG Copolymer Microfluidic Chip for Real-Time Polymerase Chain Reaction Diagnosis

Fabrication of PDMS Microfluidic Chip Used in Ultraviolet Integrated Biological Chip

Fabrication of Paper-Based Microfluidics by Spray on Printed Paper

A Liquid Molding Method for the Fabrication of Microfluidic Devices Based on a Drop-on-demand Generation of Patterned Substrates

Rapid Fabrication of Monolithic PDMS Microchips and Highly Sensitive Chemiluminescence Detection for Amino Acids

Fabrication Of Microfluidic Chip And Its Application

Feature Characterization of Microfabricated Microfluidic Chips by PDMS Replication and CCD Imaging