Abstract:For signal processing of a Micro-Electro-Mechanical System (MEMS) Inertial Measurement Unit (IMU), a digital-analog hybrid system-on-chip (SoC) with small area and low power consumption was designed and implemented in this paper. To increase the flexibility of the processing circuit, the designed SoC integrates a low-power processor and supports three startup or debugging modes for different application scenarios. An application-specific computing module and communication interface are designed in the circuit to meet the requirements of IMU signal processing. The configurable clock allows users to dynamically balance computing speed and power consumption in their applications. The chip was taped out under SMIC 180 nm CMOS technology and tested for performance. The results show that the chip's maximum running frequency is 105 MHz. The total area is 33.94 mm2. The dynamic and static power consumption are 0.65 mW/MHz and 0.30 mW/MHz, respectively. When the system clock is 25 MHz, the dynamic and static power consumption of the chip is 76 mW and 66 mW, and the dynamic and static power consumption of the FPGA level are 634 mW and 520 mW. The results verify the superiority of the application specific integrated circuit (ASIC) solution in terms of integration and low power consumption.

Low power EEPROM designed for sensor interface circuit

Circuits and Implementation of a Low-Power Embedded EEPROM Memory

An Ultra-Low-Power Embedded EEPROM for Passive RFID Tags

Low power Embedded EEPROM design for MCU in battery-less tire pressure monitoring system

A Single-Poly EEPROM with Low Leakage Charge Pump and Peripheral Circuits for Passive RFID Tag in a Standard CMOS Technology

A low power 64K-bit eeprom for battery-less TPMS SoC

A Low-Power Portable ECG Sensor Interface with Dry Electrodes

High Power-Efficiency Readout Circuit for MEMS Capacitive Accelerometer

Optimisation Design For Eeprom Embedded In Uhf-Rfid Passive Transponders

Design of Ultra-Low-Power Electrocardiography Sensors

A Pure Logic Cmos Based Low Power Non-Volatile Random Access Memory For Rfid Application

Design of an EEPROM IP for RF ID's

A Low-Power, Single-Poly, Non-Volatile Memory for Passive RFID Tags

An Ultra-Low-power CMOS Temperature Sensor for RFID Applications

Design Techniques for A 30-Ns Access Time 1.5-V 200-Kb Embedded Eeprom Memory

[An Ultra-Low Power, Wearable, Long-Term ECG Monitoring System with Mass Storage].

Ultra-Low-Power Interface Chip for Autonomous Capacitive Sensor Systems

Design and Implementation of an On-Chip Low-Power and High-Flexibility System for Data Acquisition and Processing of an Inertial Measurement Unit.

Pure logic CMOS based embedded Non-Volatile Random Access Memory for low power RFID application

The Implementation of Low Power SoC Chip and Solution for Portable Blood Glucose Meter

A Low-Power CMOS Smart Temperature Sensor for RFID Application