Abstract:This paper proposes low-power design of embedded dynamic random-access memory (eDRAM) using emerging nanoelectromechanical (NEM) relay devices. The motivation of this work is to reduce the standby refresh power consumption through the improvement of retention time of eDRAM cells. In this paper, it is revealed that the tunable beyond-CMOS characteristics of emerging NEM relay devices, especially the ultra-high OFF-state drain-source resistance, open up new opportunities with device-circuit co-design. In addition, the pull-in and pull-out threshold voltages are tilled to fit the operating mechanisms of eDRAM, so as to support low-voltage operations along with long retention time. Excitingly, when low-gate-leakage thick-gate transistors are used together, the proposed NEM-relay-based eDRAM exhibits so significant retention time improvement that it behaves almost "nonvolatile". Even if using thin-gate transistors in a 130nm CMOS, the evaluation of the proposed eDRAM shows up to 63x and 127x retention time improvement at 1.0V and 1.4V supply, respectively. Detailed performance benchmarking analysis, along with the practical CMOS-compatible NEM relay model, the eDRAM design and optimization considerations, is included in this paper.

Low power Embedded EEPROM design for MCU in battery-less tire pressure monitoring system

A low power 64K-bit eeprom for battery-less TPMS SoC

Circuits and Implementation of a Low-Power Embedded EEPROM Memory

An Ultra-Low-Power Embedded EEPROM for Passive RFID Tags

Low power EEPROM designed for sensor interface circuit

A Single-Poly EEPROM with Low Leakage Charge Pump and Peripheral Circuits for Passive RFID Tag in a Standard CMOS Technology

Optimisation Design For Eeprom Embedded In Uhf-Rfid Passive Transponders

A 125khz Low Frequency Power Recovery Circuit for Battery-Less Tpms Soc

Design Techniques for A 30-Ns Access Time 1.5-V 200-Kb Embedded Eeprom Memory

A Low Power LDO Design for Battery-Less TPMS.

Pure logic CMOS based embedded Non-Volatile Random Access Memory for low power RFID application

A Low Power MCU Design for Battery-Less TPMS SoC

A Dual Core Oxide 8T SRAM Cell with Low Vccmin and Dual Voltage Supplies in 45nm Triple Gate Oxide and Multi Vt CMOS for Very High Performance Yet Low Leakage Mobile SoC Applications

A Fully Logic CMOS Compatible Non-Volatile Memory for Low Power IoT Applications

Design of an EEPROM IP for RF ID's

A Novel Low-Power 8 Bit SAR ADC for Battery-less TPMS SoC

A Low-Power, Single-Poly, Non-Volatile Memory for Passive RFID Tags

Design Of Almost-Nonvolatile Embedded Dram Using Nanoelectromechanical Relay Devices

Mixed-Signal Soc Design and Low Power Research for Tire Pressure Monitoring Systems

A Pure Logic Cmos Based Low Power Non-Volatile Random Access Memory For Rfid Application

Design of Dynamic Power Management for System on Chip in batteryless TPMS