Abstract:This paper investigated the micromechanical behavior of different 6H-SiC/Al systems during the uniaxial tensile loading by using molecular dynamics simulations. The results showed that the interface models responded diversely to the tensile stress when the four low-index surfaces of the Al were used as the variables of the joint surfaces. In terms of their stress–strain properties, the SiC(0001)/Al(001) models exhibited the highest tensile strength and the smallest elongation, while the other models produced certain deformations to relieve the excessive strain, thus increasing the elongation. The SiC(0001)/Al(110) models exhibited the largest elongations among all the models. From the aspect of their deformation characteristics, the SiC(0001)/Al(001) model performed almost no plastic deformation and dislocations during the tensile process. The deformation of the SiC(0001)/Al(110) model was dominated by the slip of the 1/6 Shockley partial dislocations, which contributed to the intersecting stacking faults in the model. The SiC(0001)/Al(111) model produced a large number of dislocations under the tensile loading. Dislocation entanglement was also found in the model. Meanwhile, a unique defect structure consisting of three 1/6 stair-rod dislocations and three stacking faults were found in the model. The plastic deformation in the SiC(0001)/Al(112) interface model was restricted by the L-C lock and was carried out along the 1/6 stair-rod dislocations’ direction. These results reveal the interfacial micromechanical behaviors of the 6H-SiC/Al composites and demonstrate the complexity of the deformation systems of the interfaces under stress.

Tensile mechanical behaviors of cubic silicon carbide thin films

Microstructural and Mechanical Properties of Cubic Silicon Nitride: Insights from Molecular Dynamics Simulation

Mechanical properties of Si(1−x)–C(x): strength and stiffness of materials using LAMMPS molecular dynamics simulation

Computational Study of the Nanoscale Mechanical Properties of C-S-H Composites under Different Temperatures

Cubic silicon carbide under tensile pressure: Spinodal instability

Effect of Different Oxide Thickness on the Bending Young'S Modulus of Sio2@Sic Nanowires

Microstructure, mechanical and high-temperature tribological properties of amorphous SiC films by pulsed magnetron sputtering

Growth and Mechanical Properties of Amorphous and Nanostructured SiC films

Effect of crystal orientation and temperature on the mechanical properties and fracture mechanism of silicon carbide nanowires

Measurement and Analysis on the Mechanical Properties of Silicon Carbide Film

Effects of Composition and Thermal Annealing on the Mechanical Properties of Silicon Oxycarbide Films

Tensile Properties of Two-Dimensional Carbon Fiber Reinforced Silicon Carbide Composites at Temperatures Up to 1800 °C in Air

Thermal and Mechanical Properties of Amorphous Silicon Carbide Thin Films Using the Femtosecond Pump-Probe Technique

Influence of Microstructures on Mechanical Behaviours of SiC Nanowires: a Molecular Dynamics Study

Mechanical Properties of Silicon Carbonitride Thin Films

Optical and surface properties of 3C–SiC thin epitaxial films grown at different temperatures on 4H–SiC substrates

Uniaxial-stress Effects on Electronic Properties of Silicon Carbide Nanowires

Study on the Mechanical Property of High‐Performance Silicon Carbide Fiber

Tensile Properties of Two-Dimensional Carbon Fiber Reinforced Silicon Carbide Composites at Temperatures Up to 2300 °C

Mechanical tensile behavior-induced multi-level electronic transport of ultra-thin SiC NWs

Molecular Dynamics Study of Interfacial Micromechanical Behaviors of 6H-SiC/Al Composites under Uniaxial Tensile Deformation