Abstract:The influence of temperature in the range from 20 to 100 °C on the specific surface energy and fracture toughness of standard silicon wafers of three orientations (100), (110) and (111) was studied. Silicon wafers were heated on a special thermal platform with an autonomous heating controller, which was installed under the samples. At each temperature, the samples were kept for 10 min. The specific surface energy γ after exposure to temperature was determined by atomic force microscopy (AFM). Fracture toughness during and after exposure to temperature was determined by indentation followed by visualization of the deformation region using AFM. It has been established that the specific surface energy γ of Si wafers with orientation (100) and (111) increases with increasing temperature from 20 to 100 °C, and for orientation (110) it increases at temperatures from 20 to 80 °C, and then decreases. The diagonal length d of indentation marks, performed both during the heating process and after heating, decreases by increasing the temperature from 20 to 100 °C. The crack length c decreases on silicon wafers during indentation during heating from 20 to 100 °C, and after exposure to temperature, the length increases. When the plates are exposed to temperature, the fracture toughness K IC increases with increasing temperature: for orientation (100) – up to 1.61 ± 0.08 MPa·m 1/2 , for (110) – up to 1.60 ± 0.08 MPa·m 1/2 and for (111) – up to 1.66 ± 0.04 MPa·m 1/2 . A direct correlation was established between K IC , measured during exposure to temperature, and an inverse correlation between K IC measured after exposure to temperature and specific surface energy for the (100) and (111) orientations. An inverse correlation was obtained by K IC at the (110) orientation when exposed to temperatures of 20–40 and 80–100 °C, and after exposure, a direct correlation was obtained. At 60 °C there is no correlation. The results obtained can be used to improve the mechanical properties of silicon wafers used in solar cells and microelectromechanical systems (operating at temperatures up to 100 °C).

Effect of crystal orientation and temperature on the mechanical properties and fracture mechanism of silicon carbide nanowires

Size-Dependent Brittle-To-Ductile Transition in Silica Glass Nanofibers

The Effects of Morphology and Temperature on the Tensile Characteristics of Carbon Nitride Nanothreads.

Influence of Microstructures on Mechanical Behaviours of SiC Nanowires: a Molecular Dynamics Study

Low-Temperature In Situ Large Strain Plasticity Of Ceramic Sic Nanowires And Its Atomic-Scale Mechanism

Mechanical properties of Si nanowires as revealed by in situ transmission electron microscopy and molecular dynamics simulations.

Response of mechanical properties and subsurface damage in β-SiC to temperature and crystal plane during nanoindentation simulation

Lattice Bending, Disordering, and Amorphization Induced Plastic Deformation in a SiC Nanowire

Computational Study of the Nanoscale Mechanical Properties of C-S-H Composites under Different Temperatures

Influence of Reinforcement with Multimodal Distribution on Thermophysical Properties and Fracture Behavior in Al-Si/SiC Composites Infiltrated under Super-Gravity Field

Molecular dynamics simulation of the temperature effect on ideal mechanical properties of SiC/BN interface for SiCf/SiC composites

Phase-field-crystal Simulation of Nano-Single Crystal Microcrack Propagation under Different Orientation Angles

Effects of microstructures on the fracture properties of silicon nitride ceramics at elevated temperatures

Uniaxial-stress Effects on Electronic Properties of Silicon Carbide Nanowires

Thermal softening-suppressed inter-granular embrittlement of polycrystalline 3C-SiC under diamond cutting

Theoretical Investigation on the Influence of Temperature and Crystallographic Orientation on the Breaking Behavior of Copper Nanowire.

Effects of temperature and strain rate on dynamic crack propagation in brittle silicon

Atomistic simulations on ductile-brittle transition in <111> BCC Fe nanowires

Strain effect on thermal conductivity of 3C-SiC nanowire

Influence of Temperature from 20 to 100 °C on Specific Surface Energy and Fracture Toughness of Silicon Wafers

Understanding Large Plastic Deformation of SiC Nanowires at Room Temperature