Abstract:Sodium-ion batteries (SiBs) are highly promising to substitute lithium-ion batteries (LiBs) in wide applications, such as energy storage. The metal sulfide or selenium are candidate anodes for high-energy density SiBs resulting from their theoretically higher initial coulombic efficiency, higher conductivity, and lower voltage polarization. Herein, we found that GeSe2 is more favorable than GeS2 for Na ion storage. The first-principle calculation revealed that the formation energy of GeSe2 is 54.997 kJ mol–1 less than that of GeS2, Ge–Se bonds are easier to rebuild than Ge–S bonds, and Na2Se is easier to decompose than Na2S. The experimental investigation proved that all Na ions are reversible in a GeSe2/Na battery system when the operated voltage window was fixed in 0.01–3 V, which is not realized in a GeS2/Na battery. With galvanization discharge/charge voltage fixed in 0.01–2.5 V, the reversible capacity of GeSe2/C in the 1st, 2nd, 50th, and 100th cycles was 638, 540, 481, and 427 mAh g–1 at 100 mA g–1, while the corresponding values of GeS2/C were only 987, 408, 213, and 162 mA g–1, respectively. The rate charge capacity of GeSe2/C was about 416, 344, 317, 263, 215, 188, 165, and 458 mAh g–1 at 0.5, 1, 2, 3, 4, 5, 6, and 0.2 A g–1, and the corresponding capacity of GeS2 is 294, 228, 200, 159, 128, 110, 98, and 282 mAh cm–1, respectively. The research possibly provides a designable route for the preparation of high-energy density and high-reversibility SiB anodes; i.e., MxSey may be more favorable than MxSy for Na ion storage.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c02292.Additional data analysis including band structures of (a) Na2S, (b) Na2Se, (c) GeS2, and (d) GeSe2 (Figure S1) (PDF)This article has not yet been cited by other publications.

Ga2se3 Thin Film As A Negative Electrode Material for Lithium-Ion Batteries

Facile Scalable Synthesis Of Carbon-Coated Ge@C And Gex@C (X=S, Se) Anodes For High Performance Lithium-Ion Batteries

Fabrication and Lithium Electrochemistry of InSe Thin Film

Manganese Selenide Thin Films As Anode Material for Lithium-Ion Batteries

Pulsed Laser Deposited Sb2Se3 Anode for Lithium-Ion Batteries

Lithium Electrochemistry of A Novel Snse Thin-Film Anode

Nanocomposite SnO2–Se Thin Film As Anode Material for Lithium-Ion Batteries

Fabrication and Lithium Electrochemistry of Ag2Se Thin Film Anode

Lithium Electrochemistry of NiSe2: A New Kind of Storage Energy Material

Nanocomposite Fe2O3–Se as a new lithium storage material

Electrochemical Reactivity of Nanocomposite ZnO–Se for Lithium-Ion Batteries

High-Rate Performance All-Solid-State Li-SeS2 Battery with Selenium Sulphide/three-Dimensional Graphene As Cathode Material

Physical vapor deposition of Sb 2 Se 3 films as high-performance anode materials in quasi-solid-state Li-ion batteries

Electrochemical Reactivity Mechanism of CuInSe2 with Lithium

A Novel Synthesis of Vse2 As a High-Rate Lithium-Ion Battery Anode Material

A Facile Pre-Lithiated Strategy towards High-Performance Li2Se-LiTiO2 Composite Cathode for Li-Se Batteries

Facile and efficient synthesis of Li2Se particles towards high-areal capacity Li2Se cathode for advanced Li–Se battery

Study on the Electrochemical Features of Carbon-Coated GeS 2 and GeSe 2 Anodes toward Application in Sodium-Ion Battery

Monolayer germanium monochalcogenides (GeS/GeSe) as cathode catalysts in nonaqueous Li-O 2 batteries.

Using first-principles study on the characteristics of γ-GeSe as anode of sodium-ion battery

Three-dimensional graphene-wrapped Co0.85Se@C as high volumetric capacity anode material for lithium-ion batteries