Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

Electrochemical Reactivity of Nanocomposite ZnO–Se for Lithium-Ion Batteries

Se-p Orbitals Induced "strong D-D Orbitals Interaction" Enable High Reversibility of Se-Rich ZnSe/MnSe@C Electrode As Excellent Host for Sodium-Ion Storage

Nanocomposite SnO2–Se Thin Film As Anode Material for Lithium-Ion Batteries

In-situ Imaging Electrocatalysis in a Solid-State Li-O2 Battery with CuSe Nanosheets As Air Cathode

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Nanocomposite Fe2O3–Se as a new lithium storage material

Pulsed Laser Deposited NiO–NiSe Nanocomposite As a New Anode Material for Lithium Storage

Fabrication and Electrochemical Characterization of Zinc Selenide Thin Film by Pulsed Laser Deposition

Lithium Electrochemistry of NiSe2: A New Kind of Storage Energy Material

SnO2/ZnO composite structure for the lithium-ion battery electrode

ZnSe nanoparticles dispersed in reduced graphene oxides with enhanced electrochemical properties in lithium/sodium ion batteries

Preparation and electrochemical properties of mesoporous Si/ZrO2 nanocomposite film as anode material for lithium ion battery

Fabrication and Lithium Electrochemistry of InSe Thin Film

Lithium Electrochemistry of A Novel Snse Thin-Film Anode

Electrochemistry Of Zno1-Xsx Thin Film With Lithium

Manganese Selenide Thin Films As Anode Material for Lithium-Ion Batteries

Electrochemical Reactivity Mechanism of CuInSe2 with Lithium

Nitrogen-doped Carbon Encapsulated Hollow ZnSe/CoSe2 Nanospheres As High Performance Anodes for Lithium-Ion Batteries.

Electrochemical reactivity of Co–Li2S nanocomposite for lithium-ion batteries

Zinc-cobalt-bimetallic catalyst on three-dimensional ordered nitrogen-doped porous carbon for high-performance lithium-selenium batteries

SnSb–ZnO composite materials as high performance anodes for lithium-ion batteries