Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

Nanocomposite Fe2O3–Se as a new lithium storage material

Pulsed Laser Deposited NiO–NiSe Nanocomposite As a New Anode Material for Lithium Storage

Pulsed Laser Deposited Heterogeneous Mixture of Li2Se–Sb2Se3 Nanocomposite As a New Storage Lithium Material

Nanocomposite SnO2–Se Thin Film As Anode Material for Lithium-Ion Batteries

Lithium Electrochemistry of NiSe2: A New Kind of Storage Energy Material

Electrochemical Reactivity of Nanocomposite ZnO–Se for Lithium-Ion Batteries

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Hollow Structured Carbon@FeSe Nanocomposite As a Promising Anode Material for Li‐Ion Batteries

Li3n-Co Nanocomposite: A New Promising Lithium-Ion Storage Material

Hierarchical MOF-derived Layered Fe3O4 QDs@C Imbedded on Graphene Sheets As a High-Performance Anode for Lithium-ion Storage

LiF∕Co Nanocomposite As a New Li Storage Material

One-Step Route to Fe2O3 and FeSe2 Nanoparticles Loaded on Carbon-Sheet for Lithium Storage

One-Step Route to Fe<sub>2</sub>O<sub>3</sub> and FeSe<sub>2</sub> Nanoparticles Loaded on Carbon-Sheet for Lithium Storage

Interfacial Lithiation Induced Leapfrog Phase Transformation in Carbon Coated Se Cathode Observed by In-Situ TEM

Multielement-Doped Fe x Se y /Carbon Nanotube Composites for High Performance Sodium-Ion Storage

Combinatorial Investigations of Co-LiF and Co-Li3N Nanocomposite As New Lithium Storage Material

A Facile Pre-Lithiated Strategy towards High-Performance Li2Se-LiTiO2 Composite Cathode for Li-Se Batteries

Synthesis of Fe3Se4/CoFe/NSeC@NSeC for fast and longevous energy storage

The Electrochemical Properties of LiF-Ni Nanocomposite Thin Film

Electrochemical Properties of Snse Thin Film Electrode Fabricated by Pulsed Laser Deposition

Nano-sized FeSe2 decorated rGO as a potential anode material with enhanced lithium-ion storage