Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

The Electrochemical Properties of LiF-Ni Nanocomposite Thin Film

LiF∕Co Nanocomposite As a New Li Storage Material

Pulsed Laser Deposited NiO–NiSe Nanocomposite As a New Anode Material for Lithium Storage

Combinatorial Investigations of Co-LiF and Co-Li3N Nanocomposite As New Lithium Storage Material

Nanostructured nickel fluoride thin film as a new Li storage material

AlN-Fe Nanocomposite Thin Film: A New Anode Material for Lithium-lon Batteries

Enhanced electrochemical properties of NiO–NiS nanocomposite thin film

Li3n-Co Nanocomposite: A New Promising Lithium-Ion Storage Material

Electrochemical Characterization of Li[sub 3]n–si Nanocomposite Thin Films by Pulsed Laser Deposition

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Electrochemical Properties of NiO–Ni Nanocomposite As Anode Material for Lithium Ion Batteries

Electrochemical reactivity of Co–Li2S nanocomposite for lithium-ion batteries

Nanocomposites As Anode for Lithium-Ion Battery

Nanocomposite Fe2O3–Se as a new lithium storage material

A Nanocrystalline Nio Thin-Film Electrode Prepared by Pulsed Laser Ablation for Li-Ion Batteries

Effects of Li-doped NiO on the charge–discharge properties of LiF–NiO composites used as cathode materials for Li-ion batteries

Nanostructured NiSi thin films as a new anode material for lithium ion batteries

AlN-Fe Nanocomposite Thin Film:A New Anode Material for Lithium-Ion Batteries

Electrochemical Reactivity Mechanism Of Ni3n With Lithium

Electrochemical Reactivity Mechanism of Ni[sub 3]N with Lithium

Electrochemical Investigation on Nanoflower-Like CuO/Ni Composite Film As Anode for Lithium Ion Batteries