Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

Manganese Selenide Thin Films As Anode Material for Lithium-Ion Batteries

Nanocomposite SnO2–Se Thin Film As Anode Material for Lithium-Ion Batteries

Lithium Electrochemistry of A Novel Snse Thin-Film Anode

Pulsed Laser Deposited Sb2Se3 Anode for Lithium-Ion Batteries

A novel exfoliated manganese phosphoselenide as a high-performance anode material for lithium ions storage

Hydrothermally synthesized MnSe as high cycle stability anode material for lithium-ion battery

Lithium Electrochemistry of NiSe2: A New Kind of Storage Energy Material

Physical vapor deposition of Sb 2 Se 3 films as high-performance anode materials in quasi-solid-state Li-ion batteries

Ga2se3 Thin Film As A Negative Electrode Material for Lithium-Ion Batteries

Fabrication and Lithium Electrochemistry of Ag2Se Thin Film Anode

Electrochemical Reactivity of Nanocomposite ZnO–Se for Lithium-Ion Batteries

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Encapsulating MnSe nanoparticles inside 3D hierarchical carbon frameworks with lithium storage boosted by in-situ electrochemical phase transformation.

Si-Mn Composite Anode Used for Li-ion Battery

Pulsed Laser Deposited NiO–NiSe Nanocomposite As a New Anode Material for Lithium Storage

Electrochemical properties of Si-Mn/C as anode materials for lithium ion batteries

Thin films of lithium manganese oxide spinel as cathode materials for secondary lithium batteries

High-performance MnSe 2 –MnSe heterojunction hollow sphere for aluminum ion battery

Fabrication and Lithium Electrochemistry of InSe Thin Film

Exploring Electrochemical Performance of Layered Bi 2 Se 3 Hexagonal Platelets as Anode Material for Lithium-Ion Batteries

Synthesis and Performance of Nano MnO As an Anode Material for Lithium-Ion Batteries