Abstract:Sodium-ion batteries (SiBs) are highly promising to substitute lithium-ion batteries (LiBs) in wide applications, such as energy storage. The metal sulfide or selenium are candidate anodes for high-energy density SiBs resulting from their theoretically higher initial coulombic efficiency, higher conductivity, and lower voltage polarization. Herein, we found that GeSe2 is more favorable than GeS2 for Na ion storage. The first-principle calculation revealed that the formation energy of GeSe2 is 54.997 kJ mol–1 less than that of GeS2, Ge–Se bonds are easier to rebuild than Ge–S bonds, and Na2Se is easier to decompose than Na2S. The experimental investigation proved that all Na ions are reversible in a GeSe2/Na battery system when the operated voltage window was fixed in 0.01–3 V, which is not realized in a GeS2/Na battery. With galvanization discharge/charge voltage fixed in 0.01–2.5 V, the reversible capacity of GeSe2/C in the 1st, 2nd, 50th, and 100th cycles was 638, 540, 481, and 427 mAh g–1 at 100 mA g–1, while the corresponding values of GeS2/C were only 987, 408, 213, and 162 mA g–1, respectively. The rate charge capacity of GeSe2/C was about 416, 344, 317, 263, 215, 188, 165, and 458 mAh g–1 at 0.5, 1, 2, 3, 4, 5, 6, and 0.2 A g–1, and the corresponding capacity of GeS2 is 294, 228, 200, 159, 128, 110, 98, and 282 mAh cm–1, respectively. The research possibly provides a designable route for the preparation of high-energy density and high-reversibility SiB anodes; i.e., MxSey may be more favorable than MxSy for Na ion storage.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c02292.Additional data analysis including band structures of (a) Na2S, (b) Na2Se, (c) GeS2, and (d) GeSe2 (Figure S1) (PDF)This article has not yet been cited by other publications.

Monolayer germanium monochalcogenides (GeS/GeSe) as cathode catalysts in nonaqueous Li-O 2 batteries.

Monolayer germanium monochalcogenides (GeS/GeSe) as cathode catalysts in nonaqueous Li–O<sub>2</sub>batteries

Facile Scalable Synthesis Of Carbon-Coated Ge@C And Gex@C (X=S, Se) Anodes For High Performance Lithium-Ion Batteries

In-situ Imaging Electrocatalysis in a Solid-State Li-O2 Battery with CuSe Nanosheets As Air Cathode

Monolayer Fe3GeX2 (X = S, Se, and Te) as Highly Efficient Electrocatalysts for Lithium-Sulfur Batteries

Monolayer graphitic germanium carbide (g-GeC): the promising cathode catalyst for fuel cell and lithium–oxygen battery applications

Study on the Electrochemical Features of Carbon-Coated GeS 2 and GeSe 2 Anodes toward Application in Sodium-Ion Battery

Interfacial Lithiation Induced Leapfrog Phase Transformation in Carbon Coated Se Cathode Observed by In-Situ TEM

Two-dimensional Siligraphenes As Cathode Catalysts for Nonaqueous Lithium-Oxygen Batteries

Layered GeSe/thermally-reduced graphene oxide composites as efficient anodes for high-performance Li-ion batteries

Theoretically Evaluating Two-Dimensional Tetragonal Si2Se2 and SiSe2 Nanosheets As Cathode Catalysts for Alkali Metal-O2 Batteries

A Facile Pre-Lithiated Strategy towards High-Performance Li2Se-LiTiO2 Composite Cathode for Li-Se Batteries

Lithiation of Single-Crystalline Ge(111) and Si(111) Investigated by X-ray Photoelectron Spectroscopy

Using first-principles study on the characteristics of γ-GeSe as anode of sodium-ion battery

2D SnSe Cathode Catalyst Featuring an Efficient Facet‐Dependent Selective Li 2 O 2 Growth/Decomposition for Li–Oxygen Batteries

Electronic "Bridge" Construction via Ag Intercalation to Diminish Catalytic Anisotropy for 2D Tin Diselenide Cathode Catalyst in Lithium–Oxygen Batteries

CoSe 2 -decorated carbon nanofibers: A catalytic electrode for uniform Li 2 Se nucleation in lithium-selenium batteries

Influence of Carbon Matrix Dimensions on the Electrochemical Performance of Germanium Oxide in Lithium-Ion Batteries

Immobilization of GeS2 on exfoliated graphite sheet for high-capacity lithium-ion battery anodes

An Integrated Hybrid Interlayer for Polysulfides/selenides Regulation Toward Advanced Li–SeS2 Batteries

Understanding the electrochemical processes of SeS 2 positive electrodes for developing high-performance non-aqueous lithium sulfur batteries