Abstract:To clarify the mechanism of positive-ionic and neutral desorptions from heated lithium halide (LiX, X = F, Cl, Pr or I), a small amount (approx. 10(-12)-10(-7) mol) of LiX was deposited on a platinum plate (ca. 0.03-0.04 cm(2)) to prepare a thin film (theta(0) = 10(-1)-10(3) molecular layers at the start), and it was heated up to ca. 1500 K at a constant rate (beta = 0.4-140 K/s) in vacuum (approx. 10(-4) Pa) using our dual-ion source system which made it possible to measure simultaneously the desorption rates (D-0 and D+) of neutral molecule (LiX0) and ion (Li+). The temperature-programmed desorption spectra thus obtained were different in pattern from that observed previously with NaX where each of NaX0 and Na+ had only one peak. Namely, the high peaks (P-1(0) and P-2(+)) of LiX0 and Li+ appeared at a temperature generally lower and higher than the melting point (T-m) of each LiX, respectively, while low peaks (P-1(+), P-2(0), P-0(3) and P-3(+)) appeared usually above T-m. Theoretical analysis of the beta-dependence of peak appearance temperatures yields the activation energies (E-1(0+)-E-3(0+)) for desorption of LiX0 (or Li+) giving P-1(0+)-P-3(0+), respectively, and also the frequency factors (nu(1)(0+)-nu(2)(0+)) corresponding to respective peaks. With respect to LiF (theta(0) approximate to 13 molecular layers), for example, E-1(0) and E-1(+) were 220 and 167 kJ/mol, respectively, while nu(1)(0) and nu(1)(+) were respectively 1 x 10(17) and 8 x 10(10)/s. In conclusion, (1) each desorption obeys the first-order kinetics, (2) P-1(0)-(0)(3) originate from the desorption from LiX at the state of physical adsorption, crystal or chemisorption, (3) P-1(+)-P-3(+) are due to the desorption from active sites (high work function sites; e.g., 724 kJ/mol for LiCl)on the heterogeneous surface of LiX itself or Pt, and (4) the ionization efficiency (D+/D-0) even at P-1(+)-P-3(+) is usually less than 1% mainly because the fraction of the active sites is less than 1% of the desorbing surface area. (C) 2000 Elsevier Science B.V. All rights reserved.

Optimum Temperature Range for Positive Ion Production from Metal Halide Molecules Incident Upon Heated Metal Catalysts

General Applicability of Our Empirical Formulae Expressing the Threshold Temperature Range for Dissociative Positive Ionization of Halide Molecules on Heated Metal Surfaces

Selection of the Substrate Metal Best for Thermal Positive Ionization

Effective work functions of polycrystalline refractory metals heated for thermal positive-ionic and electronic emissions

Activation Energies For The Desorption Of Neutral Molecules And Positive Ions From Alkali-Halide Layers Heated On A Metal Surface

Thermolytic Formation Of Iro2+Ta2o5 Mixed Oxides Anodes Made From Chloride Precursors

Thermal Positive-Ionic and Electronic Emissions from Iridium Heated in Vacua

Effective work functions for thermal positive-ionic and electronic emissions from tantalum heated in a high vacuum

Temperature-programmed desorption study of the surface states during positive-ionic and neutral-molecular desorption from a lithium halide film on platinum

Sticking probability of metal halide molecules incident upon refractory metal surfaces heated in high vacua

Activation energies for thermal ionic and neutral desorptions from thin films of lithium halides

Thermodynamic Prediction of Metastable Phases of Ni-Ti System Formed by Ion Beam Mixing

Temperature dependence of irradiation-induced amorphization in a high-entropy titanate pyrochlore

The electron–phonon coupling constant and the Debye temperature in polyhydrides of thorium, hexadeuteride of yttrium, and metallic hydrogen phase III

Thermochemical and Thermionic Properties of Ionic Crystalline Films

Deciphering the Reaction Between A Hydrated Electron and A Hydronium Ion at Elevated Temperatures

Dielectronic recombination rate coefficients for the Ni I isoelectronic sequence

The Problem of the Influence of the Nature of Metal on the Electrocatalytic Process and Its Solution Based on a Combination of the Vacancy Thermodynamic Model and Equilibrium Statistical Thermodynamics

Understanding High-Temperature Chemical Reactions on Metal Surfaces: A Case Study on Equilibrium Concentration and Diffusivity of CxHy on a Cu(111) Surface

Structures and stabilities of titanium hydride surfaces: a first-principles thermodynamic study

Beyond Boltzmann: thermalization of cluster catalyst ensembles can extend beyond reaction timescales