Temperature-programmed desorption study of the surface states during positive-ionic and neutral-molecular desorption from a lithium halide film on platinum

Yongfa Zhu,Takanori Maeda,Hiroyuki Kawano
DOI: https://doi.org/10.1016/S0167-2991(97)80859-2
1997-01-01
Abstract:In order to clarify the surface states during thermal desorption of positive ions (Li+) and neutral molecules (LiX0) from a thin film ( theta(0) approximate to 1 - 10(4) molecular layers at the start) of lithium halide (LiX) deposited on a platinum surface, a dual-ion source system developed by us was employed together with a technique of temperature-programmed desorption (TPD) at the heating rate (beta) of similar to 2 - 80 K/s in vacuum (similar to 5 x 10(-5) Pa), and both ionic and neutral desorption rates (D+ and D-0) were simultaneously determined as a function of theta(0) or beta. Theoretical analysis of TPD spectra thus obtained yields the results as follows. (1) Desorption of LiCl0 exhibits two peaks at the temperatures of T-1(0) approximate to 700 - 800 K and T-2(0) approximate to 1000 - 1300 K, beta-dependence of which affords the activation energies of E-1(0) = 1.5 eV and E-2(0) = 2.9 eV. (2) Both D-1(0) at T-1(0) and D-2(0) at T-2(0) are proportional to beta or theta(0), corresponding to the desorptions from non-active sites on the sample surface itself below and above the melting point (883 K), respectively. (3) Desorption of Li+ from LiCl shows three peaks at T-1(+) approximate to 900 - 1100 K, T-2(+) approximate to T-2(0) and T-3(+) approximate to 1100 - 1350 K, the latter two of which yield E-2(+) = 3.0 eV and E-3(+) = 2.4 eV, corresponding to the desorptions from active sites (high work function spots) on the heterogeneous surfaces of LiCl and Pt, respectively. (4) The fractional surface area of the active sites over each surface is as small as similar to 10(-3) - 10(-6). (5) At any of T-1(+) - T-3(+), D+ is proportional to neither beta nor theta(0) but to the thickness at each peak temperature. (6) Similar spectra found with LiF afford E-1(0) = 2.9 eV, E-2(0) = 4.1 eV, E-1(+) = 2.0 eV and E-2(+) = 3.4 eV. (7) Each desorption obeys the first-order kinetics.
What problem does this paper attempt to address?