Abstract:In order to clarify the surface states during thermal desorption of positive ions (Li+) and neutral molecules (LiX0) from a thin film ( theta(0) approximate to 1 - 10(4) molecular layers at the start) of lithium halide (LiX) deposited on a platinum surface, a dual-ion source system developed by us was employed together with a technique of temperature-programmed desorption (TPD) at the heating rate (beta) of similar to 2 - 80 K/s in vacuum (similar to 5 x 10(-5) Pa), and both ionic and neutral desorption rates (D+ and D-0) were simultaneously determined as a function of theta(0) or beta. Theoretical analysis of TPD spectra thus obtained yields the results as follows. (1) Desorption of LiCl0 exhibits two peaks at the temperatures of T-1(0) approximate to 700 - 800 K and T-2(0) approximate to 1000 - 1300 K, beta-dependence of which affords the activation energies of E-1(0) = 1.5 eV and E-2(0) = 2.9 eV. (2) Both D-1(0) at T-1(0) and D-2(0) at T-2(0) are proportional to beta or theta(0), corresponding to the desorptions from non-active sites on the sample surface itself below and above the melting point (883 K), respectively. (3) Desorption of Li+ from LiCl shows three peaks at T-1(+) approximate to 900 - 1100 K, T-2(+) approximate to T-2(0) and T-3(+) approximate to 1100 - 1350 K, the latter two of which yield E-2(+) = 3.0 eV and E-3(+) = 2.4 eV, corresponding to the desorptions from active sites (high work function spots) on the heterogeneous surfaces of LiCl and Pt, respectively. (4) The fractional surface area of the active sites over each surface is as small as similar to 10(-3) - 10(-6). (5) At any of T-1(+) - T-3(+), D+ is proportional to neither beta nor theta(0) but to the thickness at each peak temperature. (6) Similar spectra found with LiF afford E-1(0) = 2.9 eV, E-2(0) = 4.1 eV, E-1(+) = 2.0 eV and E-2(+) = 3.4 eV. (7) Each desorption obeys the first-order kinetics.

Effective work functions for thermal positive-ionic and electronic emissions from tantalum heated in a high vacuum

Effective work functions of polycrystalline refractory metals heated for thermal positive-ionic and electronic emissions

Thermal Positive-Ionic and Electronic Emissions from Iridium Heated in Vacua

Thermal Equation of State, and Melting and Thermoelastic Properties of Bcc Tantalum from Molecular Dynamics

Relationship Between the Thermoelectric Properties and Infrared Emissivity of Nb-Doped TiO2

Work function and surface stability of tungsten-based thermionic electron emission cathodes

Temperature-programmed desorption study of the surface states during positive-ionic and neutral-molecular desorption from a lithium halide film on platinum

High‐Pressure Synthesis and Thermal Conductivity of Semimetallic θ‐Tantalum Nitride

Tantalum Microwave Resonators with Ultra-High Intrinsic Quality Factors

Sticking probability of metal halide molecules incident upon refractory metal surfaces heated in high vacua

Vacancy Suppression and Resonant Level Rendering Extraordinary Power Factor in Sn0.99In0.01Te/Tourmaline Composite

An Investigation of Oxides of Tantalum Produced by Pulsed Laser Ablation and Continuous Wave Laser Heating

Optimum Temperature Range for Positive Ion Production from Metal Halide Molecules Incident Upon Heated Metal Catalysts

General Applicability of Our Empirical Formulae Expressing the Threshold Temperature Range for Dissociative Positive Ionization of Halide Molecules on Heated Metal Surfaces

Investigating Thermionic Emission Properties of Polycrystalline Perovskite BaMoO 3

Thermionic Emission As a Tool for Measuring the Work Function of Anodic Titanium Dioxide

Evaporation of cations from non-conductive nano-samples using single-cycle THz pulses: an experimental and theoretical study

Activation Energies For The Desorption Of Neutral Molecules And Positive Ions From Alkali-Halide Layers Heated On A Metal Surface

Phonon and Thermal Properties of Exfoliated Tantalum Diselenide Thin Films

Electron-induced non-monotonic pressure dependence of the lattice thermal conductivity of θ-TaN

On the work function of the surface Mo(0 0 1) and its temperature dependence: an ab initio molecular dynamics study