Abstract:Cu-Cu bonding presents an attractive approach to bottom-up manufacturing, facilitating nanoparticle production, linking, and restoration. The ramifications of varying bonding depths and orientations exhibit distinct characteristics. At the same time, investigations into the material composition of nanoscale bonded pairs involve scrutiny of atomic slippage, strain distribution, and the force-displacement profile. The methodology simulates the Cu-Cu bonding process by implementing the quasi-continuum (QC) approach, constituting a multifaceted mixed molecular dynamics technique integrating atomistic and continuum methods. The analysis of results reveals variations in the Contact effect induced by the four orientations, along with discrepancies in the atomic slippage observed in distinct directions. Notably, a pronounced distinction is discernible in the directional movement. Specifically, the strained regions on the flat surface of the lower substrate, characterized by the directionality of X[001]-Y[110], exhibit a notably broader range of atomic slip compared to regions strained by alternative orientations. Furthermore, the directional alignment of X[110]-Y[111] illustrates that irrespective of whether the lower substrate's surface is flat or rough, the orientation of atomic slip diverges. In conclusion, our study employed a quasi-continuous method to explore the bonding efficacy of copper-to-copper interfaces on flat and irregular substrate surfaces. Through this approach, we scrutinized the distributions of strain, stress, average Newtonian force, and atom differential arrangement direction across different orientations.

Internal Stress and Adhesion of Cu Film/Si Prepared by Both Mevva and Ibad

Metal vapor vacuum-arc ion implantation effects on the adhesion and hardness of ion-beam deposited Cr/Cu films

A New Method to Obtain Cu Films with Lower Resistivity and Higher Interface Adhesion on Different Substrates

Diffusion and Adhesion Properties of Cu Films on Polyimide Substrates

Study on elastic modulus of ultra-thin copper films by in-situ SEM-SPM nanoindentation

Properties of Cu Film and Ti/Cu Film on Polyimide Prepared by Ion Beam Techniques

Effect of High-Frequency and High-Density Current on Adhesive Strength of Copper Thin Film

Cu Films by Partially Ionized Beam Deposition for Ultra Large Scale Integration Metallization

Preparation of Cr Hard Coatings by Ion Beam Assisted Electron Beam Vapor Deposition on Ni and Cu Substrates

The Effect of CU Intermediate Layer Made by IBAD on the CU Surface Film of E-Gun Evaporation

Synthesis of Molybdenum Silicide by Both Ion Implantation and Ion Beam Assisted Deposition

The Effect of Cu Orientation on Fracture Location in Cu<inf>3</inf>Sn-Cu Interface Structure Under Monotonic Loading Condition by Molecular Dynamics Simulation

Stress–strain behavior of Cu on the AMB‐Si3N4 substrate undergoing thermal cycles via in situ strain measurement

The Effect Of Cu Orientation On Fracture Location In Cu3sn-Cu Interface Structure Under Monotonic Loading Condition By Molecular Dynamics Simulation

Study of internal stress on electroplating copper used in through silicon via filling

Determination of yielding and debonding in Al–Cu thin films from residual stress measurements via diffraction

Bonding of copper to silicon chips using vapor-deposited tin film

Microstructural effects of copper deposits on direct bonding for 3D IC integration

Effect of heat treatment on the peel strength of two kinds of Cu film

Measurement of Thermal Stress by X-ray Nano-Diffraction in (111)-Oriented Nanotwinned Cu Bumps for Cu/SiO2 Hybrid Joints

Study on copper-to-copper bonding of three-dimensional integrated circuits using the quasicontinuum method