Abstract:Growth and micromachining of single crystal silicon carbide (SiC) have drawn extensive attention in wide bandgap semiconductors and remained challenging. The micromechanical properties (i.e., hardness, elastic modulus, fracture toughness), which are the key to machinability and machining quality (and therefore the yield of the grown SiC), of 4H–SiC were assessed by nanoindentation, microhardness, and microscratch tests. Consistent values of true indentation hardness of 4H–SiC can be obtained by different approaches without the need for the area function of the indenter. Accurate determination of elastic modulus (i.e., 583.5 GPa) and indentation hardness (i.e., 38 GPa) of 4H–SiC by the instrumented indentation technique requires low loads with slight indentation-induced damage. Consistent values of fracture toughness K c of 4H–SiC were obtained by different methods such as the Vickers/Berkovich indenter-induced cracking method (2.1 MPa·m 1/2 ), energy-based nanoindentation approaches (the critical void volume fraction of 0.062 should be used for 4H–SiC when the deterioration of indentation hardness is used), and linear elastic fracture mechanics (LEFM)-based scratch approach with a spherical indenter (2.6 MPa·m 1/2 ). This work provides the guidance for the mechanical machining of 4H–SiC wafers and the paradigm of micromechanical characterization of brittle solids by indentation and scratch technologies.

Mechanical Properties of SiC Coatings on Spherical Particles Measured Using the Micro-Beam Method

Young’s Modulus Measurements of SiC Coatings on Spherical Particles by Using Nanoindentation

Influence of SiC Coating Thickness on Mechanical Properties of SiCf/SiC Composite

A Study of the Microstructure and Mechanical Properties of Sic Coatings on Spherical Particles

Mechanical Behavior of SiCf/SiC Composites with Alternating PyC/SiC Multilayer Interphases

Measurement and Analysis on the Mechanical Properties of Silicon Carbide Film

Anisotropic Deformation of 4H-Sic Wafers: Insights from Nanoindentation Tests

Mechanical Property and Ballistic Performance of Silicon Carbide

Micromechanical properties characterization of 4H–SiC single crystal by indentation and scratch methods

Experimental and Numerical Investigations of Tensile Properties of SiC Particle‐Reinforced Composites

Microstructure and Room-Temperature Mechanical Properties of Β Sialon/sic Nanocomposites

Fracture Behavior of SiC-TiB2 Composite Measured by Different Test Methods

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Mechanical characterization of biocompatible thin film materials by scanning along micro-machined cantilevers for micro-/nano-system

Mechanical properties of Si(1−x)–C(x): strength and stiffness of materials using LAMMPS molecular dynamics simulation

Study on Mechanical Properties of Single-Crystal Silicon Carbide by Nanoindentation

Investigation of the bulging mechanism of C/SiC coating through in situ optical observation and numerical simulation

Mechanical Properties of Mono-crystalline Silicon Thin Films Measured by Different Methods

Microstructure, Mechanical, and Tribological Properties of Cr-Ti-Si-N Coatings

Evaluation of Mechanical Properties and Strain Criterion for Realibility Design of Micromachined Polysilicon Thin Films

Particle Shape Effects on Ductility of Sic Particle Reinforced Ld2 Matrix Composites Investigated by Afm-Based Nanoindentation