Abstract:Dense B4C ceramic matrix composites were synthesized by reactive hot press sintering at the temperature of 1800 degrees C and the pressure of 35 MPa using commercial available B2O3, Al, graphite, and B4C as raw materials. Micro structure, phase composition and mechanical properties were observed and tested. The composite ceramics were penetrated by a 7.62 mm calibre armor-piercing bullet at restrained and unrestrained states. Then the protection factor was calculated according to the rules of DOP method. In comparison, the ballistic performances of AZ ceramic and monolithic B4C were also investigated. The results indicated that the mam phase of the as-prepared sample was B4C (similar to 70wt%) and the secondary phase was A1(2)O(3). A complex intermediate phase contained Al-B-O was found filled in the holes between the main phase and the secondary phase. Density, hardness, bending strength and fracture toughness of the composite were 2.82 g/cm(3), 41.5 GPa, 380 Mpa, and 3.9 MPa center dot m(1/2), respectively. The fracture toughness significantly increased by 85.7s% as compared with that of the pure B4C (2 1 MPa center dot m(1/2)). The protection factor of the composite ceramic gets 11% and 70% increase compared to those of AZ ceramic and monolithic B4C, respectively. At restrained states, the protection factors of all the samples are further improved by about 10%. These results suggested that B4C/A1(2)O(3) composite ceramic prepared by reactive hot press sintering method might be a good ceramic armor material.

Mechanical Property and Ballistic Performance of Silicon Carbide

Influence of Silicon Addition on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

Study on the Mechanical Property of High‐Performance Silicon Carbide Fiber

Microstructural and thermal stress effects on mechanical properties of boron carbide particle‐reinforced silicon carbide

The impact of Si3N4 incorporation on the mechanical characteristics of ZrB2-SiC nanocomposite sintered via pressureless method

Effects of boron source on properties of pressureless solid-state sintered silicon carbide ceramics

Effect of Nano SiC on Microstructure and Mechanical Properties of BN-ZrO2-SiC Multiphase Ceramics

Mechanical properties and microstructure of laminated Si3N4+SiCw/BN+Al2O3 ceramics densified by spark plasma sintering

Aqueous Processing, Hot-Pressing and Mechanical Properties of Silicon Carbide with Al2O3 and Y2O3

Microstructure and Room-Temperature Mechanical Properties of Β Sialon/sic Nanocomposites

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

Enhanced toughness and hardness at cryogenic temperatures of silicon carbide sintered by SPS

Effect of Activator on Properties of SiC Porous Ceramics

Effect of Tungsten Carbide on Densification and Mechanical Properties of Silicon Nitride Ceramics by Spark Plasma Sintering

Effects of Particle Reshaping on Forming and Sintering of Silicon Carbide Ceramic Seals

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Microstructure and mechanical properties of SiC composite ceramics modified by (TixZr1–x)B2 solid solution

Effects of SiC contents on the microstructure and mechanical properties of Al4SiC4–SiC ceramic composites

B4C-SiC composites with tuneable mechanical properties: Role of Al2O3 - Y2O3 sintering additives

Ballistic Performance of B4C/Al2O3 Composite Ceramic Prepared by Reaction Sintering

Mechanical Properties Of Carbon/Silicon Carbide Composites Materials Bolts