Abstract:Dislocation loops in quenched aluminum alloys are usually seen deviating from their nominal habit planes, while the orientation distribution and deviation mechanism are far from understanding. Based on the method of tomographic crystallography of dislocations and correlative in-situ heating experiments in transmission electron microscopy (TEM), we revisit the three-dimensional (3D) characteristics and deviation behaviors of dislocation loops in a quenched Al-Cu alloy with an aim to fully unravel the relationship between dislocation crystallography and deviation behaviors. The results show that all the dislocation loops exhibit approximately circular shapes and have a/2 < 110>-type Burgers vectors, with loop orientations deviating from their pure edge orientation {110} of 0°-17.8° and distributing mainly close to the [101]-[001] and [101]-[111] edges of the standard stereographic triangle. Three types of deviation behaviors of dislocation loops are then defined, which are characterized by loop rotation around 〈100〉, 〈110〉 and irregular axes, respectively. Theoretical calculations of strain energy variation with increasing deviation angle indicate that the relatively low energy barrier may account for a high frequency of loop deviation in the low angle range. Detailed in-situ TEM heating experiments and correlative tomographic crystallography analyses strongly demonstrate the specific roles of dislocation gliding and climbing at elevated temperatures in the shrinkage, polygonization and deviation processes of dislocation loops, and the competitive and cooperative motion of dislocation segments close to slip planes {111} are the fundamental reasons for the formation of three types of deviated dislocation loops.

Dislocation generation and propagation in Czochralski Alexandrite single crystals

X-Ray Topographic Investigation of Dislocations in Czochralski-Grown Alexandrite (beal2o4cr) Single-Crystal

Crystal-Growth And Dislocation Arrangement Of Czochralski Alexandrite (Beal2o4-Cr) Single-Crystals

DISLOCATIONS AND INCLUSIONS IN CZOCHRALSKI METHOD-GROWN YAG SINGLE CRYSTALS

Preface of 16th International Conference on Defects, Recognition, Imaging and Physics in Semiconductors

X-ray Topographic Observation of Dislocation Structure in Sapphire Single Crystal Grown by Temperature Gradient Technique

Photoluminescence of Dislocations in Czochralski Silicon Induced During Crystal Growth

Investigation of Dislocation Migration in Substrate-Grade CdZnTe Crystals During Post-Annealing

A study of dislocations generated by inclusions in gadolinium gallium garnet crystals by birefringence topography

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Dislocation Formation in Czochralski Si Crystal Growth Using an Annealed Heavily B-Doped Si Seed

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

Study of Dislocations in Cdznte Single Crystals

Resolving localized geometrically necessary dislocation densities in Al-Mg polycrystal via in situ EBSD

Dislocation slip systems in c-plane and m-plane AlN single crystals under nano-indentation

Orientation distribution and deviation behaviors of dislocation loops in a quenched Al-Cu alloy

Experimental Characterization of Dislocations in Deformation Induced Planar Boundaries of Rolled Aluminium

Dislocations Observed by Transmission Electron-Microscopy in the Quasi-Crystalline Phase T2 of Al-Li-Cu after Deformation

Dislocation proliferation at the growth crystal/seed interface of physical vapor transport-grown 4H-SiC crystals

Study on Dislocation of Ce3+: YAG Crystal

Transmission Electron Microscopy Observation of a Dislocation Loop in an Al70Co15Ni15decagonal Quasicrystal