Abstract:Solidification end reduction is an effective approach to control the central porosity during continuous casting of round bloom, although it is not widely reported. In the present work, a three-dimensional finite element model has been developed with coupling heat transfer and mechanical deformation for a φ690 mm continuously cast round bloom, and verified by the surface temperature, shrinkage zone width, reduction crack location, and deformed contour shape. It is found that the contact width between roller and the bloom increases with the increase of reduction amount and approximately in a parabolic relationship. To cover the whole range of the shrinkage zone, the total reduction amount should not be smaller than 25 mm as the width of the shrinkage zone is about 120 mm. The bulge width along the horizontal direction during reduction increases as the total reduction amount increases, and the relationship can be fitted by a parabolic equation. The reduction thickness in the shrinkage zone is larger when the reduction amount is higher, and it also follows parabolic relationship. The deformation in the shrinkage zone is more obvious when the reduction is conducted before crater end. The reduction efficiency for φ690 mm round bloom before solidification is between 20 and 30 pct, while after solidification is roughly between 12 and 20 pct. It increases with the increase of apparent reduction amount, mainly related to the increase of the strain rate. The deformation of the shrinkage zone in φ690 mm round bloom with 30 mm apparent reduction in continuous casting and hot rolling has been compared. The equivalent strain in the shrinkage zone of the round bloom in continuous casting is about 0.047 to 0.052, while that in hot rolling is about 0.031 to 0.036, indicating the reduction efficiency of the former is about 1.5 times higher than the latter.

Finite Element Analysis of Thermal Shrinkage for Continuous Casting Bloom

Modelling of continuous casting processes parameters on the shrinkage cavity formation in bearing steel blooms

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Analysis of Thermomechanical Behavior in Continuous Bloom Casting Mold

Finite element numerical simulation on Thermo Mechanical couple in bloom mold

Thermomechanical Model of Heat Transffer in Bloom Casting Mold

Analysis of Casting Roll Temperature Distribution and Thermal Deformation in Twin-Roll Continuous Strip Casting

Numerical Study on Temperature Behavior of Beam Blank Continuous Casting Molds

Numerical Simulation of Solidification and Heat Transfer in Continuously Cast Bloom

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Finite Element Thermal-Mechanical Coupled Analysis of Strand Bulging Deformation in Continuous Casting

Thermomechanical Analysis and Optimisation for Beam Blank Continuous Casting

A Three Dimensional Real-time Heat Transfer Model for Continuous Casting Blooms

Numerical simulation of shrinkage porosity defect in billet continuous casting

Study and Application of a Simplified Soft Reduction Amount Model for Improved Internal Quality of Continuous Casting Bloom

FINITE ELEMENT ANALYSIS OF THERMO-MECHANICAL COUPLED SOLIDIFICATION PROCESS OF CONTINUOUS CASTING SLAB IN MOLD

Numerical Simulation on Thermo-Mechanical Coupling in Bloom Mold by Finite Element Method

The Design of mould taper for continuous casting steels based on solidification shrinkage simulation

Heat Transfer Simulation for Covers in Continuous Casting Process of Steel and Its Application

Reduction Behavior in Large-Sized Round Bloom During Continuous Casting by Numerical Simulation

Effect of Roll Surface Profile on Thermal-Mechanical Behavior of Continuously Cast Bloom in Soft Reduction Process