Abstract:A finite element computational methodology is presented for predicting the temperature distribution, fluid flow, and thermal stresses evolving in a solidifying ingot, which itself is growing in length, during the start-up phase of a continuous casting process, with a particular reference to aluminum casting. The approach is based on the coupling of a thermal and flow model with a stress model, The thermal flow model is developed using a deforming finite element method with an Eulerian-Lagrangian transformation to account for the fact that the ingot itself is also growing at a prescribed casting speed. The stress model is developed also by the finite element method, with mechanical deformations in the solidifying materials described by a hypoelastic-viscoplastic constitutive relation. The integrated model has been applied to study the dynamic development of temperature, flow, and stresses in the solidifying ingot during the start-up phase for continuous casting of aluminum. The results show that the fluid flow and temperature distribution experience a rapid change at the initial stage but that the change slows down later in the process as it approaches to the steady state. Computed results compare reasonably well with experimental measurements for temperature distributions in the ingot. It is found that the thermal stresses in general evolve from small to big in magnitude and from compressive to tensile in the solidifying ingot. The hoop stress is larger than other stress components, in particular in the outer surface region. The air gap formed between the ingot and the bottom block increases initially and decreases afterward as a result of stress relaxation.

Finite Element Thermal-Mechanical Coupled Analysis of Strand Bulging Deformation in Continuous Casting

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Fine analysis of section stress of steel strand

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Finite element numerical simulation on Thermo Mechanical couple in bloom mold

Analysis of Thermomechanical Behavior in Continuous Bloom Casting Mold

Numerical Simulation on Thermo-Mechanical Coupling in Bloom Mold by Finite Element Method

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Finite Element Analysis of Shell Growth in a Continuous Casting Mold

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Thermomechanical Analysis and Optimisation for Beam Blank Continuous Casting

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Thermomechanical Model of Heat Transffer in Bloom Casting Mold

Numerical simulation on solidification and thermal stress of continuous casting billet in mold based on meshless methods

Thermal stress simulation considering mechanical interaction between casting and mold

Integrated Simulation of Castings Deformation during Casting and Heat Treatment Processes

A Thermomechanical Finite Element Model for Simulating the Solidification Process of Squeeze Casting

A 2.5D finite element model for bending and straightening in continuous casting of steel slabs