Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

The Design of mould taper for continuous casting steels based on solidification shrinkage simulation

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Mould Taper Optimization for Continuous Casting Steels by Numerical Simulation

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Modelling of Steel Shrinkage and Optimisation of Mould Taper for High Speed Continuous Casting

Research and Design of Parabolic Taper Mould for High Efficiency Continuous Casting of Billet

Thermomechanical Behavior of Round Billet in Continuous Casting Mold

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Modelling of continuous casting processes parameters on the shrinkage cavity formation in bearing steel blooms

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Numerical simulation of shrinkage porosity defect in billet continuous casting

Experimental study and numerical simulation of solidification in large steel ingot

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Computational modeling and control system of continuous casting process

Three-dimensional Simulation of Solidification Process in Large Steel Ingot

Design Improvement of Four-Strand Continuous-Casting Tundish Using Physical and Numerical Simulation

FEM Analysis of Temperature and Stress Fields of Mould Wall in Continuous Casting of Steel Billet

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

Chamfer and Taper Researches of Mould in Slab Continuous Casting

Application of Solidification Simulation of Temperature Field in Heavy Steel Castings