Abstract:The hybrid process of selective noncatalytic reduction (SNCR) followed by selective catalytic reduction (SCR) is an up-to-date nitrogen oxides control technique and can achieve a high efficiency (60%-95%) with moderate cost. The SNCR/SCR hybridization was investigated through experimentation on a 100MW, coal-fired utility boiler in China. The baseline nitrogen oxides emission of the hybrid urea-based SNCR/SCR system was 170 ppm at 6% O(2) controlled by coal reburning technology. The hybrid SNCR/SCR system including only 89 m(3) catalysts could control NO emission under 25 ppm with ammonia slip <4ppm at 300-430 tons/h of boiler load. Total NO reduction efficiency was generally about 85% and could be beyond 90%, in which SCR's efficiency was 50%-70% individually and SNCRs was about 60%-75%. NO emission decreased from about 65 to 15 ppm when the flow rate of 35% urea solution increased from 0.15 to 0.47 tons/h. At higher boiler load, more urea solution had to be injected and higher layer of the agent injectors had to come into operation to hit the same emission target. The superheated steam was injected with high speed into flue gases at the inlet of reversing chamber and it was effective on enhancing both the total quantities and the distribution of SNCR's ammonia residue, which was used as reducing agent of SCR. In general there was more NH(3) where there was less NO at the inlet of catalysts and NO distribution was contrary to NH(3) distribution in some way. NO and NH(3) distribution at the outlet of catalysts was almost even compared with the inlet distribution. Average NH(3) slip at the outlet increased with NH(3) at the inlet and could be controlled below 4 ppm at 6% O(2) in any case. The difference between average NH(3) at the inlet and the outlet was smaller several times than the reduced NO by SCR catalysts. Some isocyanic acid (HNCO) as the product of urea solution thermohydrolysis might exist in the flue gas and it was hydrolyzed to NH(3) quickly on SCR catalysts, which then reduced NO on the surface of SCR catalysts.

Experimental Research on SNCR Applied in 125 MW Power Plant Boiler

Experimental Research on SNCR Applied in Power Plant Boiler: Impact of Temperature and Urea Solution Injection Volume Flow Rate

Application of Selective Non-catalytic Reduction on a Power Plant Boiler

Impact of NSR and Atomization Pressure on SNCR Used in Power Plant Boiler

Full-Scale Numerical Investigation of a Selective Noncatalytic Reduction (SNCR) System in a 100 MW Utility Boiler with Complex Chemistry and Decoupling Approach

Numerical Study of SNCR Process in Coal-Fired Boiler with Large Capacity

Experimental Study on Micronized Coal Reburning for a 200MW Coal-fired Boiler

Cost-Efficient Nitrogen Oxides Control by a Hybrid Selective Noncatalytic Reduction and Selective Catalytic Reduction System on a Utility Boiler

Application of air staging combined with SNCR on 300 MW boiler

Application of Hybrid Coal Reburning/SNCR Processes for NOx Reduction in a Coal-Fired Boiler

NOx Reduction by Aqua Ammonia Injection at 2.11 MW Tangential Pulverized Fired Boiler

Nitrous Oxide Formation and Emission in Selective Non-Catalytic Reduction Process

Application of Selective Non-catalytic Reduction Denitrification

Highly Efficient and Economical Nitrogen Oxides Controlled by an In‐furnace Urea Solution Pyrolysis Coupled with SCR System for a Coal‐fired Utility Boiler

Simulation and Optimization of SNCR Process

Experimental research on the fire-carrying problems in primary air nozzle of 125 MW units

The application of RANS CFD for design of SNCR technology for a pulverized coal-fired boiler

Industrial Experiment on NO x Reduction by Urea Solution Injection in the Fuel-Rich Zone of a 330 MW Tangentially Pulverized Coal-Fired Boiler

Numerical study of mixing characteristic between flue and droplet at 410t/h coal-fired boiler SNCR system

MODELING AND EXPERIMENTAL STUDY ON NO_x REDUCTION IN FURNACE WITH AMMONIA INJECTION

Numerical Simulation and Optimization of SNCR System for CFB Boilers