Abstract:The proton-exchange membrane fuel cell (PEMFC) bipolar plate serpentine flow channel U-shaped region is prone to the accumulation effect, which poses serious difficulties for fuel cell water management. As a result, a deep understanding of water transport in the U-shaped region is essential to improve the fuel cell performance. Under this direction, in this work, the impact of the different microstructure parameters and initial conditions on water transport in the U-shaped region was compared with and without microstructure using the volume of the fluid method. On top of that, the velocity field distribution in the X-direction and the pressure drop distribution in the flow channel were also analyzed. From the acquired results, it was demonstrated that due to the secondary flow caused by the bending property of the microstructure, the droplet movement time in the U-shaped region was significantly shortened after the microstructure was added in the U-shaped region. The initial conditions strongly affected the droplet motion, and a larger contact angle enhanced the wall hydrophobicity to facilitate the droplet discharge. An increase in the droplet diameter led also to a rise in the windward area and shear force, which shortened droplet discharge time. Interestingly, if the waveform microstructure has too-large crests, gullies will be created that will impede the droplet motion and increase the amplitude of the droplet oscillation, resulting in excessive pressure drop in the flow channel. A too-large period led to increased droplet momentum loss, whereas a short period reduced the wall contact angle, which is not conducive to drainage. The microstructure spacing significantly affected the droplet motion, and the reduced spacing increased the airflow diffusion effect to accelerate the flow rate. The main focus of this work was led on the application of the microstructure in a U-shaped region of the serpentine flow channel, which is of great specific significance for droplet removal inside the flow channel.

Pressure Drop Behavior in the Anode Flow Field of Liquid Feed Direct Methanol Fuel Cells

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Operando Liquid Pressure Determination In Polymer Electrolyte Fuel Cells

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack

Effect of Fabrication and Operating Parameters on Electrochemical Property of Anode and Cathode for Direct Methanol Fuel Cells

Enhancing the performance of direct methanol fuel cells using new cathode flow field designs: An experimental investigation

Investigation of anode flow field for direct dimethyl ether fuel cell

A Study of the Direct Dimethyl Ether Fuel Cell Using Alkaline Anolyte

Parameters research of the anode flow field of a micro direct methanol fuel cell

Study on the Effect of Temperature on Pressure Drop and Under-Rib Convection in PEMFC

Experimental Investigation on the Anode Flow Field Design for an Air-Cooled Open-Cathode Proton Exchange Membrane Fuel Cell

Numerical simulation on mass transport in a passive vapor-fed direct methanol fuel cell operating with neat methanol

Influence of liquid electrolyte and liquid flowing electrolyte on the performance of an air breathing direct methanol fuel cell (ABDMFC)

Effects of Microstructure on Water Removal in the U-Shaped Region of PEMFC Serpentine Flow Channel

The Effect of Methanol Concentration on the Performance of A Passive Dmfc

Performance of a Direct Methanol Fuel Cell

Effect of Methanol Concentration on Performance of Passive DMFC

A Neat Methanol Fed Passive DMFC with a New Anode Structure

Novel Anode Electrode Structure with a Fuel Management Layer for High-Concentration Passive Direct Methanol Fuel Cells

Numerical Simulations in a Three-dimensional Model of Direct Methanol Fuel Cell Anode Using Computational Fluid Dynamics Method