Abstract:The A15 phase superconductor Nb3Al has been considered as an alternative to Nb3Sn for high field and large scale applications. However, to prepare a stoichiometric Nb3Al with fine grain structures is very difficult. High-energy ball milling is a solid state powder processing technique and is a very useful for preparing Nb-Al alloys (Nb3Al). The effects of ball milling time and annealing temperature on the formation of Nb3Al superconducting phase have been studied. Pure Nb and Al powders with stoichiometric ratio of Nb3Al were mixed and milled, and the charging and milling were performed in an inert atmosphere. Phase formation and structural evolution during high-energy ball milling have been examined by X-ray diffraction. Al disappeared and Nb peaks broadened after about one hour of milling. With increasing milling time, the peaks of Nb became considerably broader and intensities decreased, the Nb-Al solid solution phase was extensive when milled about 3 hours. In order to obtain Nb3Al superconducting phase, a subsequent anneal was required. We have annealed the as-milled powders at 800-900°C for different times to prepared Nb3Al superconducting alloy. The results indicated that Nb3Al with small amount of impurity phase can be obtained on annealing the Nb-Al solid solution phase and the superconducting transition temperature was about 15K, but it is difficult to obtain a homogeneous Nb3Al phase by annealing the amorphous powder.

Preparation of SrAl2O4 from an oxide mixture via a high-energy ball milling

Mechanical activation of barium aluminate formation from BaCO3–Al2O3 mixtures

Preparation of Nb3al by High-Energy Ball Milling and Superconductivity

Effect of CeO_2 and ZrO_2 Additives on Microstructure and Thermal Stability of High-Energy Ball Milling Al_2O_3 Powder

Preparation of α-Al2O3 by low-temperature calcining γ-Al2O3 with α-phase seed in-situ obtained by ball milling

Preparation of nano-sized SrAl2O4 using an amorphous hetero-nucleus complex as a precursor

Formation of Nanocrystalline Fcc Phase by Mechanically Driven Crystallization

Formation of 25 Mol% Fe2o3-Al2o3 Solid Solution by High-Energy Ball Milling

Microstructural Evolution During High Energy Ball Milling of Fe2o3-Sio2 Powders

Synthesis of Nd0.7Sr0.3MnO3 Ceramics by High-Energy Ball Milling

Nano-sized amorphous alumina particles obtained by ball milling ZnO and Al powder mixture

Formation of 25 Mol % Fe<sub>2</sub>O<sub>3</sub>-Al<sub>2</sub>O<sub>3</sub> Solid Solution by High-Energy Ball Milling

Phase Transformation and Gas–solid Reaction of Al2O3 During High-Energy Ball Milling in N2 Atmosphere

High-energy ball milling of Al2O3–TiO2 powders

The research of processing of Zn/Al2O3 composite powders obtained by high energy ball milling of Al-ZnO

Effect of ball milling treatment on the microstructures and properties of Cr2AlC powders and hot pressed bulk ceramics

Amorphization in the AlC System by Mechanical Alloying

On Advancemeat of Carbothermal Reduction of Alumina by High Energy Ball Milling

Investigation on nanocrystalline TiAl based powders prepared by double-steps ball milling

Effect of Composition of Initial Powder Mixtures on Solid State Reduction Reaction During High-Energy Ball Milling

Microstructure and thermal stability of MoSi2-CoNiCrAlY nanocomposite feedstock prepared by high energy ball milling