Abstract:Ti-45Al-2Cr-2Nb-1B-0.5Ta (at.%) bulk alloys with dense and ultrafine grains were fabricated by Double Mechanical Milling (mechanical milling + heat treatment + mechanical milling) and spark plasma sintering method. The phase composition and microstructure of the milled powder and bulk alloy sintered by SPS at different temperature (900oC, 1000oC and 1100oC), and the relationship between microstructure and properties of bulk alloys were investigated. The results demonstrate that high-quality composite powders (low contaminant, size uniform distribution and elements homogeneous dispersion) can be obtained by double mechanical milling. The composite powders prepared by primary mechanical milling were uniform and partially solid solution. Ti3Al、Ti、Al3Ti and TiAl phases were found after heat treatment while Al phase disappeared. The fined grain size and particle size were achieved by subsequent mechanical milling. The whole mechanical milling leads to alloying and the refined grain and particle, which also cause lattice distortion and powders system energy increased. SPS results showed that the densified and ultrafine grained Ti-45Al-2Cr-2Nb-1B-0.5Ta alloy is mainly consisted of TiAl, Ti3Al phase and a small quantity of TiB2 phase. With the increasing of sintering temperature, grain size of TiAl based alloy increase. The mechanical properties depend on microstructure and grain size. The relationship between compression properties, bending properties and microstructure was discussed.

Investigation on nanocrystalline TiAl based powders prepared by double-steps ball milling

Preparation of ti-al based nanophase composite powder by mechanical alloying

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Microstructure evolution of TiAl composite powder during low temperature high-energy milling

SYNTHESIS OF NANOSTRUCTURED GAMMA-TiAl BASED POWDERS AND BULK ALLOYS USING HIGH ENERGY MECHANICAL MILLING AND HIP

Synthesis of Ti2alc/Al2o3 Nanocomposites by High Energy Milling and Heat Treatment

Formation Of Tib2/Tin/Ti (Cxn1-X) Nanocomposite Powder Via High-Energy Ball Milling And Subsequent Heat Treatment

Formation of Nanocrystalline Fcc Phase by Mechanically Driven Crystallization

Investigation on microstructure and properties of Ti-45Al-5.5(Cr, Nb, B, Ta) alloy prepared by double mechanical milling (DMM) and spark plasma

Formation of Tib2/Tin Nanocomposite Powder by High Energy Ball Milling and Subsequent Heat Treatment

Investigation on the Influence of Mechanical Milling on Microstructure and Thermostability of Ti/Al Mixed Powders

Microstructure and thermal stability of MoSi2-CoNiCrAlY nanocomposite feedstock prepared by high energy ball milling

Synthesis of Ti3AlC2 Powder by High Energy Ball Milling and High Temperature Heat Treatment

Mechanical milling and its influence on microstructure and electric conductivity of high mass fraction TiC / Cu composites

Microstructure And Characteristics Of Ti-Nb-Sn-Ha Composite Powder Fabricated By Mechanical Alloying

Microstructure evolution of Ti/BN powder blend during ball milling and heat treatment

EFFECTS OF HIGH-ENERGY BALL MILLING ON THE STRUCTURE AND PROPERTY OF A MULTIPHASE Al3Ti-BASED INTERMETALLIC ALLOY

Preparation of FeAl (B2) intermetallic powder by ball milling and heat treatment

The research of processing of Zn/Al2O3 composite powders obtained by high energy ball milling of Al-ZnO

Fabrication Of Nanostructural Aluminum Alloy Powder With Ball Milling Method

Synthesis and Properties of an Ultrafine Grained Ti-45al-2cr-2nb-1b-0.5ta Alloy Prepared by Double Mechanical Milling and Spark Plasma Sintering