Abstract:Ti-45Al-2Cr-2Nb-1B-0.5Ta (at.%) bulk alloys with dense and ultrafine grains were fabricated by Double Mechanical Milling (mechanical milling + heat treatment + mechanical milling) and spark plasma sintering method. The phase composition and microstructure of the milled powder and bulk alloy sintered by SPS at different temperature (900oC, 1000oC and 1100oC), and the relationship between microstructure and properties of bulk alloys were investigated. The results demonstrate that high-quality composite powders (low contaminant, size uniform distribution and elements homogeneous dispersion) can be obtained by double mechanical milling. The composite powders prepared by primary mechanical milling were uniform and partially solid solution. Ti3Al、Ti、Al3Ti and TiAl phases were found after heat treatment while Al phase disappeared. The fined grain size and particle size were achieved by subsequent mechanical milling. The whole mechanical milling leads to alloying and the refined grain and particle, which also cause lattice distortion and powders system energy increased. SPS results showed that the densified and ultrafine grained Ti-45Al-2Cr-2Nb-1B-0.5Ta alloy is mainly consisted of TiAl, Ti3Al phase and a small quantity of TiB2 phase. With the increasing of sintering temperature, grain size of TiAl based alloy increase. The mechanical properties depend on microstructure and grain size. The relationship between compression properties, bending properties and microstructure was discussed.

Microstructure evolution of TiAl composite powder during low temperature high-energy milling

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Preparation of ti-al based nanophase composite powder by mechanical alloying

Investigation on the Influence of Mechanical Milling on Microstructure and Thermostability of Ti/Al Mixed Powders

Mechanical milling and its influence on microstructure and electric conductivity of high mass fraction TiC / Cu composites

Evolution of microstructures of Ti/AI binary powders during mechanical alloying process

SYNTHESIS OF NANOSTRUCTURED GAMMA-TiAl BASED POWDERS AND BULK ALLOYS USING HIGH ENERGY MECHANICAL MILLING AND HIP

Investigation on nanocrystalline TiAl based powders prepared by double-steps ball milling

Preparation of TiAl-based alloys by mechanical milling and reactive sintering

Mechanical alloying of Ti/Al binary powders

Microstructure and Properties of A Tial Alloy Prepared by Mechanical Milling and Subsequent Reactive Sintering

Synthesis and Properties of an Ultrafine Grained Ti-45al-2cr-2nb-1b-0.5ta Alloy Prepared by Double Mechanical Milling and Spark Plasma Sintering

Eff ects of Diff erent Mechanical Alloying Parameters on Microstructure of High Temperature Nanocrystalline Cu-Ta Alloys

Investigation on microstructure and properties of Ti-45Al-5.5(Cr, Nb, B, Ta) alloy prepared by double mechanical milling (DMM) and spark plasma

Microstructural Characters of TiAl Intermetallics Prepared with Different Processes

Microstructural Evolution of AZ61-10 At.%ti Composite Powders During Mechanical Milling

Microstructure and High-Temperature Mechanical Properties of CrMnFeCoNi/TiAl Composites Prepared by Powder Metallurgy

Microstructure and Properties of Mechanically Milled AZ61 Powders Dispersed with Submicron/nanometer Ti Particulates

Effect of mechanical milling on diffusive reaction of Ti-Al composite powders

Microstructure evolution of the rapidly solidified alloy powders and composite powders

Microstructural evolution and thermal stability in a nanocrystalline lightweight TiAlV0.5CrMo refractory high-entropy alloy synthesized by mechanical alloying