Abstract:Although there are some multi-sensor methods for measuring the straightness and tilt errors of a linear slideway, they need to be further improved in some aspects, such as suppressing measurement noise and reducing precondition. In this paper, a new four-sensor method with an improved measurement system is proposed to on-machine separate the straightness and tilt errors of a linear slideway from the sensor outputs, considering the influences of the reference surface profile and the zero-adjustment values. The improved system is achieved by adjusting a single sensor to different positions. Based on the system, a system of linear equations is built by fusing the sensor outputs to cancel out the effects of the straightness and tilt errors. Three constraints are then derived and supplemented into the linear system to make the coefficient matrix full rank. To restrain the sensitivity of the solution of the linear system to the measurement noise in the sensor outputs, the Tikhonov regularization method is utilized. After the surface profile is obtained from the solution, the straightness and tilt errors are identified from the sensor outputs. To analyze the effects of the measurement noise and the positioning errors of the sensor and the linear slideway, a series of computer simulations are carried out. An experiment is conducted for validation, showing good consistency. The new four-sensor method with the improved measurement system provides a new way to measure the straightness and tilt errors of a linear slideway, which can guarantee favorable propagations of the residuals induced by the noise and the positioning errors.

Research on the inspection method of large-scale plane straightness

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

A Novel Method to Simultaneously Measure the Straightness

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Novel Enhancing Resolution Method for Measurement Straightness Error

Research on Ultrasonic Measurement of the Large Curved Surface Parts

Research on 3-Point Relaying Method Used in Dynamic Measurement of Straightness for Large Workpiece

On-Machine Measurement of the Straightness and Tilt Errors of a Linear Slideway Using a New Four-Sensor Method

Local Geometric Measurement for 3-D Curved Micro-Pipe

Study on key technologies of straightening large-scale integrated part's distortion due to machining

Research on the on-line measuring method for automated pressure straighter

A Method of Calculating Measuring Interval for Large-Size Straightness

Straightness Detection Method and Accuracy Analysis of Guide Rail Parts

A Straightening Control System for the Linear Guide Rail

Rail straightness detection method based on the cooperation of dual laser sensors

High Precision Straightness Device Based on Double-frequency Laser Interference Technique

Three-Dimensional Method Combining Linearly Structured Light Sensing and Rotary Scanning for Measuring Aviation Bearings

Rapid Strain Measurement Technique for Large-Scale Stamping Parts

A Laser Plane Attitude Evaluation Method for Rail Profile Measurement Sensors

Straightness Measurement Based On Phase Sensitive Detection Technique