Abstract:Some different amounts of nano-sized Ni powder (from 1 to 30vol.%) have been mixed with BaTiO3-based EIA X7R ceramic powders used in base metal electrode (BME) multilayer ceramic capacitors (MLCC). The X-ray diffraction (XRD) analysis indicated that no phases other than BaTiO3 and Ni were present in the doped ceramics and further suggested that no reaction took place between BaTiO3 and Ni during sintering under reducing atmosphere. The scanning electronic microscope (SEM) observation showed that the Ni particles presented homogeneous distribution in BaTiO3 ceramic matrix. It was found that the relative density decreased with increasing Ni-content while the dielectric constant at broad temperature range increased. The dielectric constant at room temperature of the ceramic with Ni-content of 28vol.% is about 6000, 2.5 times of Ni-free ceramics, 2500. When Ni-content is 30%, the ceramic became a conductor. The temperature coefficient of capacitors (TCC) of the ceramics showed decline with the increase of Ni-content. The percolation theory of insulator–metal transitions can explain the enhancement of dielectric constant. The percolation threshold of the ceramic–metal composites for dielectric constants at room temperature, fc, is 37vol.% and the critical exponent, p, is 0.6. The dielectric losses, tgδ showed the similar phenomena with ε.

Effect of Densification Mismatch on Camber Development during Cofiring of Nickel-Based Multilayer Ceramic Capacitors

Camber development during cofiring Ag-based low-dielectric-constant ceramic package

Cofiring of Integrated Magnetic/Dielectric Laminates

Effects of Silver‐Paste Formulation on Camber Development During the Cofiring of a Silver‐Based, Low‐Temperature‐Cofired Ceramic Package

Effects of green density difference on camber development during the cofiring of a bi-layer glass-based dielectric laminate

Stress Development During the Co‐firing of Integrated Ferrite/Dielectric Laminates

Effects of a non-magnetic CuZn ferrite layer on cofiring and electrical properties of a low-fire, multilayer NiCuZn ferrite inductor

The Effect of Anisotropic Shrinkage in Tape‐Cast Low‐Temperature Cofired Ceramics on Camber Development of Bilayer Laminates

Influence of inner electrode on the microstructure of BZN based MLC

Investigation on the inter-diffusion and microstructure in multilayer ceramic capacitors

Study on densification behavior of low-temperature cofiring ceramics

Investigation Of Interdiffusion In Ba(Ti,Zr)O-3-Based Y5v Multilayer Ceramic Capacitors With Ni Electrodes

Failure Mechanism of a Low‐Temperature‐Cofired Ceramic Capacitor with an Inner Ag Electrode

Interfacial Diffusion Behavior in Ni-Batio3 Mlccs with Ultra-Thin Active Layers

Effects of A/B-Site Co-Doping on Microstructure and Dielectric Thermal Stability of AgNbO3 Ceramics

Effect of Interactions at the Cofired Interface of Electrode/Ceramics on the Reliability of Lead-Based Multilayer Ceramic Capacitors

Correlative Studies on Sintering of Ni/Batio3 Multilayers Using X-Ray Computed Nanotomography and Fib-Sem Nanotomograhy

Co firing behaviors between nickel electrode and BaTiO3 ceramics in MLCC

Electrical And Reliability Characteristics Of Mn-Doped Nano Batio3-Based Ceramics For Ultrathin Multilayer Ceramic Capacitor Application

Effect of Micro Scale on Prediction of Thermal Residual Stresses in Multilayer Ceramic Capacitors (Mlccs)

Enhancement of Dielectric Properties by Additions of Ni Nano-Particles to A X7r-Type Barium Titanate Ceramic Matrix