Abstract:In this article, it is shown that numerical computational fluid dynamics simulations reveal that low‐temperature cofired ceramics (LTCC)/LTCC assemblies experience significantly higher temperatures than Si/Si during reactive bonding, due to LTCC's lower thermal conductivity. This leads to prolonged solder melting, increased stresses, and potential bonding issues. In these findings, it is suggested that optimizing solder thickness and reactive multilayer system deposition could address these thermal challenges, which are difficult to measure experimentally. Numerical computational fluid dynamics simulations have been performed on 2D sandwich models to compare the performance of low‐temperature cofired ceramics (LTCC)/LTCC and Si/Si sandwiches used in reactive bonding. In the sandwich model layers of solder, silver and a reactive multilayer used to bond the substrates are modeled. Additional to this, the surrounding air environment is also modeled. For simulating the heat released by the multilayer system, a user‐defined function in the form of a square wave is written for the heat source with a defined width, corresponding to the reaction width, and this propagates at a fixed speed. Two sandwiches, one with LTCC/LTCC, and the other with Si/Si, are simulated and their response analyzed in terms of the solidification/melting of the solder and their respective time–temperature histories.

Camber development during cofiring Ag-based low-dielectric-constant ceramic package

Effects of Silver‐Paste Formulation on Camber Development During the Cofiring of a Silver‐Based, Low‐Temperature‐Cofired Ceramic Package

Effect of Densification Mismatch on Camber Development during Cofiring of Nickel-Based Multilayer Ceramic Capacitors

Effects of green density difference on camber development during the cofiring of a bi-layer glass-based dielectric laminate

Low-temperature Co-Fired Ceramics with High Thermal Expansion and Reliability for Millimeter-Wave Antennas

The Effect of Anisotropic Shrinkage in Tape‐Cast Low‐Temperature Cofired Ceramics on Camber Development of Bilayer Laminates

Decrease in the camber degree of Au/ceramic co-fired structure for LTCC technology

Cofiring of Integrated Magnetic/Dielectric Laminates

Stress Development During the Co‐firing of Integrated Ferrite/Dielectric Laminates

Study on densification behavior of low-temperature cofiring ceramics

Effects of a non-magnetic CuZn ferrite layer on cofiring and electrical properties of a low-fire, multilayer NiCuZn ferrite inductor

The Co-Fired Behaviors Between Ag and Glass–ceramics Materials in LTCC

Research of LTCC/Cu, Ag Multilayer Substrate in Microelectronic Packaging

Large Thermal Expansion LTCC System for Cofiring with Integrated Functional Ceramics Layers

TEM and EDS investigation of heterogeneous interfaces in cofired multilayer ceramic capacitors

Effect of Interactions at the Cofired Interface of Electrode/Ceramics on the Reliability of Lead-Based Multilayer Ceramic Capacitors

Co-Firing Behavior and Interfacial Structure of BaO–TiO2–B2O3–SiO2Glass–Ceramics/NiCuZn Ferrite Composites

The origin of interfacial delamination in Au/ceramic cofired LTCC structure

2D Computational Fluid Dynamics Simulation Analysis of the Assembly of Low‐Temperature Cofired Ceramics/Low‐Temperature Cofired Ceramics and Si/Si Sandwiches by Reactive Bonding

Investigation of the bulging mechanism of C/SiC coating through in situ optical observation and numerical simulation

Co-firing Behavior of ZnTiO3 Dielectric Ceramics/ag Composites for MLCCs